Lexus NX: Front Seatback Heater
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 FRONT INNER SEAT CUSHION SHIELD LH *2 FRONT LOWER SEAT CUSHION SHIELD *3 FRONT SEAT CUSHION SHIELD LH *4 FRONT SEAT HEADREST SUPPORT *5 SEPARATE TY
Removal
REMOVAL CAUTION / NOTICE / HINT CAUTION: Wear protective gloves. Sharp areas on the parts may injure your hands. HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below i
Inspection
INSPECTION PROCEDURE 1. INSPECT SEPARATE TYPE FRONT SEATBACK COVER LH *a Component without harness connected (Separate Type Front Seatback Cover LH (Front Seatback Heater)) (a) Check the sepa
SEE MORE:
Oxygen Sensor Heater Control Circuit Low (Bank 1 Sensor 2) (P0037,P0038,P0141,P102D)
DESCRIPTION Refer to DTC P0136. Click here HINT: When any of these DTCs are stored, the ECM enters fail-safe mode. The ECM turns off the heated oxygen sensor heater in fail-safe mode. Fail-safe mode continues until the power switch is turned off. DTC No. Detection Item DTC Detection Condi
Removal
REMOVAL PROCEDURE 1. REMOVE QUARTER OUTSIDE MOULDING SUB-ASSEMBLY RH Click here 2. REMOVE QUARTER OUTSIDE MOULDING SUB-ASSEMBLY LH Click here 3. REMOVE REAR FLOOR SIDE MEMBER COVER Click here 4. REMOVE REAR BUMPER COVER Click here 5. REMOVE ELECTRICAL KEY ANTENNA NOTICE: Do not reuse dro
© 2016-2024 Copyright www.lexunx.com
