Lexus NX: Installation
INSTALLATION
PROCEDURE
1. INSTALL WINDSHIELD WIPER SWITCH ASSEMBLY
(a) Attach the claw to install the windshield wiper switch assembly.
(b) Connect each connector.
2. INSTALL UPPER STEERING COLUMN COVER
(a) Attach the claw and install the upper steering column cover.
(b) Attach the 4 clips and 2 guides to connect the instrument cluster finish panel cover to the upper steering column cover.
3. INSTALL LOWER STEERING COLUMN COVER SUB-ASSEMBLY (for Manual Tilt and Manual Telescopic Steering Column)
NOTICE:
If the lower steering column cover sub-assembly is installed in the incorrect order, the parts may break.
(a) Attach the 3 claws and 4 guides to install the lower steering column cover sub-assembly.
(b) Turn the steering wheel assembly to the left and install the screw.
(c) Turn the steering wheel assembly to the right and install the lower steering column cover sub-assembly with the screw.
4. INSTALL LOWER STEERING COLUMN COVER SUB-ASSEMBLY (for Power Tilt and Power Telescopic Steering Column)
NOTICE:
If the lower steering column cover sub-assembly is installed in the incorrect order, the parts may break.
(a) Attach the 2 claws and 4 guides to install the lower steering column cover sub-assembly.
(b) Install the screw.
(c) Turn the steering wheel assembly to the left and install the screw.
(d) Turn the steering wheel assembly to the right and install the lower steering column cover sub-assembly with the screw.
5. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL (for Manual Tilt and Manual Telescopic Steering Column)
Click here .gif)
6. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL (for Power Tilt and Power Telescopic Steering Column)
NOTICE:
-
Reset the auto away/return function setting to the previous condition by changing the customize parameter
Click here
-
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click here
7. INITIALIZATION AFTER RECONECTING AUXILIARY BATTERY TERMINAL
Click here
HINT:
When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.
Click here
8. INSTALL DECK FLOOR BOX LH
Click here
9. INSTALL REAR DECK FLOOR BOX
Click here
10. INSTALL NO. 3 DECK BOARD SUB-ASSEMBLY
Click here
READ NEXT:
SEE MORE:
Luggage Compartment Room Light
ComponentsCOMPONENTS ILLUSTRATION *1 NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY - - RemovalREMOVAL PROCEDURE 1. REMOVE NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY (for LH Side) (a) Put protective tape around the No. 1 luggage compartment light assembly. Protective Tape (b) Using
Antenna Coil Open / Short (B2784)
DESCRIPTION When an open or short circuit is detected in the transponder key amplifier coil built into the power switch, the certification ECU (smart key ECU assembly) stores this DTC. This DTC is also stored as a past DTC. DTC No. Detection Item DTC Detection Condition Trouble Area Note
