Lexus NX: Satellite Radio Broadcast cannot be Selected or After Selecting Broadcast, Broadcast cannot be Added into Memory
CAUTION / NOTICE / HINT
NOTICE:
- Some satellite radio broadcasts require payment. A contract must be made between a satellite radio company and the user. If the contract expires, it will not be possible to listen to the broadcast.
-
When replacing the radio receiver assembly, always replace it with a new one.
If a radio receiver assembly which was installed to another vehicle is used, the following may occur:
- A communication malfunction DTC may be stored.
- The radio receiver assembly may not operate normally.
HINT:
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Audio and Visual System.
Click here .gif)
PROCEDURE
| 1. | CHECK RADIO RECEIVER ASSEMBLY |
(a) Check radio condition.
OK:
Broadcast cannot be selected
| Result | Proceed to |
|---|---|
| Broadcast cannot be selected. | OK |
| Broadcast cannot be selected, but selection cannot be memorized. | NG |
| OK | .gif) | ADD PRESET CHANNEL INTO MEMORY AGAIN |
|
.gif)
| 2. | CHECK RADIO RECEIVER ASSEMBLY |
(a) Check the number of preset channels.
OK:
36 channels have already been preset.
| OK | | END (ONLY 36 CHANNELS CAN BE PRESET) |
|
| 3. | CHECK AUXILIARY BATTERY |
(a) Check if the auxiliary battery was replaced.
OK:
Auxiliary Battery was not replaced.
| OK | | REPLACE RADIO RECEIVER ASSEMBLY |
|
| 4. | ADD PRESET CHANNEL INTO MEMORY AGAIN |
(a) Check if the preset channels that have been cleared can be added into memory again.
OK:
Preset channels can be added into memory.
| OK | | END |
| NG | | PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE |
READ NEXT:
Noise Occurs
PROCEDURE 1. CHECK NOISE CONDITION (a) Check from which direction the noise comes (front left or right, or rear left or right). OK: The location of the noise source can be determined. NG
No Sound can be Heard from Speakers
PROCEDURE 1. CHECK AUDIO SETTINGS (a) In sound output setting mode, set volume, fader and balance to the initial values and check that the sound is normal. OK: Audio system returns to normal
Sound Quality is Bad Only when Disc is Played (Volume is Too Low)
CAUTION / NOTICE / HINT NOTICE: When replacing the radio receiver assembly, always replace it with a new one. If a radio receiver assembly which was installed to another vehicle is used, the following
SEE MORE:
System Description
SYSTEM DESCRIPTION SLIDING ROOF SYSTEM DESCRIPTION (a) The sliding roof system controls the sliding roof operation using the sliding roof drive gear sub-assembly (sliding roof ECU). Operating the map light assembly sliding (slide roof switch) results in electrical power being transmitted to the slid
Replacement
REPLACEMENT PROCEDURE 1. REMOVE NO. 1 ENGINE UNDER COVER Click here 2. DRAIN COOLANT (for Inverter Coolant) NOTICE: Collect the drained coolant and measure its volume to establish a benchmark. When adding coolant, make sure to add more coolant than the measured amount. (a) Remove the inverter re
