Lexus NX: A/C Inverter Low Voltage Power Resource System Malfunction (B1477)
DESCRIPTION
The compressor with motor assembly monitors the inverter control power voltage in the circuit. The hybrid vehicle control ECU stops the compressor control and stores this DTC when the monitored voltage is outside the specified range.
This DTC will be stored as a history DTC. Compressor control may not resume unless the power switch is turned off.
DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Memory | Note |
B1477 | A/C Inverter Low Voltage Power Resource System Malfunction | An open or short to ground in the inverter control power voltage circuit | -
Compressor with motor assembly
-
CAN communication system
| Memorized | - |
CAUTION / NOTICE / HINT
CAUTION:
-
Wear insulated gloves and pull out the service plug grip before inspection as procedures may require disconnecting high-voltage connectors. Carry the removed service plug in your pocket to prevent other technicians from accidentally reconnecting it while you are servicing the vehicle.
-
Do not touch the high-voltage connectors or terminals for 10 minutes after the service plug grip is removed.
PROCEDURE
1. | CHECK CAN COMMUNICATION SYSTEM |
(a) Using the Techstream, check if the CAN communication system is functioning normally.
Click here
Result | Proceed to |
CAN communication system DTCs are not output | A |
CAN communication system DTCs are output | B |
A | | REPLACE COMPRESSOR WITH MOTOR ASSEMBLY |
B | | GO TO CAN COMMUNICATION SYSTEM |
READ NEXT:
DESCRIPTION The air conditioning harness assembly connects the air conditioning amplifier assembly and the servo motors. The air conditioning amplifier assembly supplies power and sends operation inst
DESCRIPTION The hybrid vehicle control ECU and compressor with motor assembly communicate via a direct line. Compressor control is stopped and this DTC is stored if communication information is cut of
DESCRIPTION The air conditioning amplifier assembly detects the windshield glass surface temperature from this circuit. The air conditioning amplifier assembly applies voltage to the air conditioning
SEE MORE:
DESCRIPTION The certification ECU (smart key ECU assembly) generates a request signal and transmits the signal to the rear door outside handle assembly (for front passenger side) (electrical key antenna) at intervals of 0.25 seconds. For the rear door outside handle assembly (for front passenger sid
REMOVAL CAUTION / NOTICE / HINT CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.
If the side airbag was deployed, replace the front seat airbag assembly LH, separate type front seatback spring assembly, seatback felt, separate type front seatback cover and separa
© 2016-2024 Copyright www.lexunx.com