CAUTION / NOTICE / HINT
NOTICE:
If a radio receiver assembly which was installed to another vehicle is used, the following may occur:
HINT:
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Navigation System.
Click here
PROCEDURE
1. | CHECK RADIO RECEIVER ASSEMBLY |
(a) Check radio condition.
OK:
Broadcast cannot be selected
Result | Proceed to |
---|---|
Broadcast cannot be selected. | OK |
Broadcast cannot be selected, but selection cannot be memorized. | NG |
OK | ADD PRESET CHANNEL INTO MEMORY AGAIN |
|
2. | CHECK RADIO RECEIVER ASSEMBLY |
(a) Check the number of preset channels.
OK:
36 channels have already been preset.
OK | END (ONLY 36 CHANNELS CAN BE PRESET) |
|
3. | CHECK AUXILIARY BATTERY |
(a) Check if the auxiliary battery was replaced.
OK:
Auxiliary Battery was not replaced.
OK | REPLACE RADIO RECEIVER ASSEMBLY |
|
4. | ADD PRESET CHANNEL INTO MEMORY AGAIN |
(a) Check if the preset channels that have been cleared can be added into memory again.
OK:
Preset channels can be added into memory.
OK | END |
NG | PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE |