Lexus NX: Operation Check

OPERATION CHECK

CHECK BASIC FUNCTIONS

(a) When the back door is partially closed, check that the motor operates to fully close (lock) the back door.

(b) Check that the back door can be opened.

(c) When the back door is partially closed and then the motor starts normal operation, push the back door opener switch assembly and pull up the back door to open it. At this time, check that the motor starts reverse operation and then stops.

(d) Immediately after the back door is partially closed (the motor has not started operation yet), push the back door opener switch assembly to open the back door. Check that the motor does not operate at this time.

READ NEXT:

 Problem Symptoms Table

PROBLEM SYMPTOMS TABLE HINT: Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of

 Terminals Of Ecu

TERMINALS OF ECU CHECK MULTIPLEX NETWORK DOOR ECU (a) Disconnect the Y26 and Y27 multiplex network door ECU connectors. (b) Measure the voltage and resistance according to the value(s) in the table b

 Dtc Check / Clear

DTC CHECK / CLEAR CHECK FOR DTC (a) Turn the power switch off. (b) Connect the Techstream to the DLC3. (c) Turn the power switch on (IG). (d) Turn the Techstream on. (e) Enter the following menus: Bod

SEE MORE:

 Vehicle Control History

VEHICLE CONTROL HISTORY NOTICE: When checking the vehicle control history, first record the output codes and after clearing the history, check the output history again. CHECK VEHICLE CONTROL HISTORY (LANE TRACING ASSIST SYSTEM) (a) Connect the Techstream to the DLC3. (b) Turn the power switch on (IG

 Rear Power Window Switch

ComponentsCOMPONENTS ILLUSTRATION *1 REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY *2 REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL *3 REAR DOOR ARMREST BASE PANEL - - RemovalREMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for th

© 2016-2026 Copyright www.lexunx.com