Lexus NX: Sound of Portable Player cannot be Heard from Speakers or Sound is Low
PROCEDURE
1. | CHECK PORTABLE PLAYER SETTINGS |
(a) Check the portable player settings.
(1) Check that the volume is not set to "0".
(2) Check that mute is off.
(b) Check that the sound of the portable player can be heard from the speakers.
OK:
Sound of the portable player can be heard from the speakers.
OK | | END |
NG | | |
(a) Check the audio settings.
(1) Check that the volume is not set to "0".
(b) Check that the sound of the portable player can be heard from the speakers.
OK:
Sound of the portable player can be heard from the speakers.
OK | | END |
NG | | |
3. | CHECK USING ANOTHER "Bluetooth" AUDIO COMPATIBLE VEHICLE OF SAME MODEL |
(a) Check that the sound of the portable player can be heard from the speakers of another "Bluetooth" audio compatible vehicle of the same model.
OK:
Sound of the portable player can be heard from the speakers.
NG | | MALFUNCTION IN PORTABLE PLAYER |
READ NEXT:
CAUTION / NOTICE / HINT NOTICE: When replacing the radio receiver assembly, always replace it with a new one. If a radio receiver assembly which was installed to another vehicle is used, the following
PROCEDURE 1. CHECK USING ANOTHER "Bluetooth" AUDIO COMPATIBLE VEHICLE OF SAME MODEL (a) Check if track information is displayed normally on another "Bluetooth" audio compatible vehicle of the
CAUTION / NOTICE / HINT HINT:
Perform this check with the portable player volume set at an appropriate level.
Make sure that there are no obstructions between the portable player and radio receiv
SEE MORE:
DISASSEMBLY PROCEDURE 1. REMOVE AIR CONDITIONING RADIATOR ASSEMBLY (a) Disconnect the No. 1 blower damper servo sub-assembly connector. (b) Detach the 3 clamps and remove the air conditioning harness assembly. (c) Remove the 2 screws. (d) Detach the 2 claws and remove t
DESCRIPTION Signals are input into the front power seat switch LH. The built-in ECU manages the signals received from the power seat switch, and operates each motor. If the front power seat switch LH receives more than 2 motor operation signals, the motor is stopped. Manual operation is restarted af
© 2016-2024 Copyright www.lexunx.com