Lexus NX: Black Screen
PROCEDURE
| 1. | CHECK DISPLAY SETTING |
(a) Check that the display is not in screen off mode.
OK:
The display setting is not in screen off mode.
| NG | .gif) | CHANGE SCREEN TO SCREEN ON MODE |
|
.gif)
| 2. | CHECK IMAGE QUALITY SETTING |
(a) Check that the display settings (contrast, brightness) can be set.
OK:
Setting is possible.
| OK | | SET SCREEN COLOR QUALITY TO NORMAL |
| NG | | PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE |
.gif)
READ NEXT:
Steering Pad Switch Circuit
DESCRIPTION This circuit sends an operation signal from the steering pad switch assembly to the radio receiver assembly. If there is an open in the circuit, the audio system cannot be operated using t
Illumination Circuit
DESCRIPTION Power is supplied to the radio receiver assembly and steering pad switch assembly when the light control switch is in the tail or head position. WIRING DIAGRAM CAUTION / NOTICE / HINT NOT
Speaker Circuit
DESCRIPTION If there is a short in a speaker circuit, the stereo component amplifier assembly detects it and stops output to the speakers. As a result, sound cannot be heard from the speakers even if
SEE MORE:
Installation
INSTALLATION PROCEDURE 1. INSTALL NO. 1 AMPLIFIER ANTENNA ASSEMBLY (a) Attach the guide and install the No. 1 amplifier antenna assembly with the bolt. Torque: 8.3 N·m {85 kgf·cm, 73 in·lbf} (b) Connect the 2 connectors. 2. INSTALL BACK DOOR TRIM BOARD ASSEMBLY Click here 3. INSTALL BACK DOOR
Hybrid Powertrain Control Module (P0A1D-721,P0A1D-722,P0A1D-723,P0A1D-787,P0A1D-818)
DESCRIPTION The hybrid vehicle control ECU monitors its internal operation, it will store a DTC and perform fail-safe control if it detects the following malfunction. If the following DTC is output, replace the hybrid vehicle control ECU. DTC No. Detection Item DTC Detection Condition Troub
© 2016-2025 Copyright www.lexunx.com
