Lexus NX: Disc cannot be Inserted or is Ejected Right After Insertion
CAUTION / NOTICE / HINT
NOTICE:
When replacing the radio receiver assembly, always replace it with a new one.
If a radio receiver assembly which was installed to another vehicle is used, the following may occur:
- A communication malfunction DTC may be stored.
- The radio receiver assembly may not operate normally.
HINT:
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Navigation System.
Click here .gif)
PROCEDURE
| 1. | CHECK IF A PROPER DISC IS INSERTED |
(a) Make sure that the disc is an audio disc or a disc with an MP3, WMA or AAC file, and that it is not deformed, flawed, stained, deteriorated or otherwise defective.
OK:
Disc is normal.
HINT:
- Translucent or uniquely-shaped CDs cannot be played.
- CDs and DVDs with adhesive paper labels should not be played.
- Commercial audio CDs and DVDs can be played.
- CD-DA files on CD-ROMs, CD-Rs and CD-RWs can be played.
- MP3, WMA and AAC files on CD-ROMs, CD-Rs and CD-RWs can be played.
- For details on playable CDs and DVDs, refer to the Owner's Manual.
| NG | .gif) | CHANGE DISC |
|
.gif)
| 2. | CHECK THAT DISC IS INSERTED PROPERLY |
(a) Check if the disc is inserted upside down.
OK:
Disc is properly inserted.
| NG | | SET DISC PROPERLY |
|
| 3. | CLEAN DISC AND RECHECK |
| (a) Disc cleaning (1) If dirt is on the disc surface, wipe it clean with a soft cloth from the inside to the outside in a radial direction. OK: Malfunction disappears. NOTICE: Do not use a conventional record cleaner or antistatic preservative. |
|
.png)
| OK | | END (DISC IS DIRTY) |
|
| 4. | REPLACE DISC AND RECHECK |
(a) Replace the disc with a known good one and check that the malfunction disappears.
OK:
Malfunction disappears.
| OK | | END (DISC IS DEFECTIVE) |
| NG | | REPLACE RADIO RECEIVER ASSEMBLY |
READ NEXT:
Disc cannot be Ejected
CAUTION / NOTICE / HINT NOTICE: When replacing the radio receiver assembly, always replace it with a new one. If a radio receiver assembly which was installed to another vehicle is used, the following
CD/DVD Sound Skips
CAUTION / NOTICE / HINT NOTICE: When replacing the radio receiver assembly, always replace it with a new one. If a radio receiver assembly which was installed to another vehicle is used, the following
Radio Broadcast cannot be Received or Poor Reception
WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: When replacing the radio receiver assembly, always replace it with a new one. If a radio receiver assembly which was installed to another vehicle is use
SEE MORE:
Sensor (Motor) Failure (B2341,B2344)
DESCRIPTION When the sliding roof drive gear sub-assembly (sliding roof ECU) detects a motor malfunction and the sliding roof operation is stopped, DTC B2341 is stored. When the sliding roof drive gear sub-assembly (sliding roof ECU) detects a gear position malfunction and the sliding roof operation
Headlamp LH Circuit (B2439,B243A)
DESCRIPTION This DTC is output when the headlight ECU sub-assembly receives an abnormal signal from the headlight unit. The headlight ECU sub-assembly LH outputs DTC B2439 and B243A DTC No. Detection Item DTC Detection Condition Trouble Area B2439 Headlamp LH Circuit Headlight ECU s
