Lexus NX: Terminals Of Ecu
Lexus NX Service Manual / Engine & Hybrid System / Cruise Control / Road Sign Assist System / Terminals Of Ecu
TERMINALS OF ECU
NOTICE:
- DTCs may be output when connectors are disconnected during inspection. Therefore, be sure to clear the DTCs using the Techstream once the inspection has been completed.
- Do not apply larger loads than necessary since the connector may be damaged.
CHECK FORWARD RECOGNITION CAMERA
(a) Measure the voltage and resistance according to the value(s) in the table below.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| T18-7 (IGB) - T18-10 (GND) | GR - W-B | Power source | Power switch on (IG) | 11 to 14 V |
| Power switch off | Below 1 V | |||
| T18-10 (GND) - Body ground | W-B - Body ground | Ground | Always | Below 1 Ω |
READ NEXT:
Diagnosis System
DIAGNOSIS SYSTEM DIAGNOSIS FUNCTION (a) The road sign assist system displays a warning message on the multi-information display to inform the driver that the system is unavailable when it is malfuncti
Dtc Check / Clear
DTC CHECK / CLEAR CHECK DTC (a) Connect the Techstream to the DLC3. (b) Turn the power switch on (IG). (c) Turn the Techstream on. (d) Enter the following menus: Body Electrical / Road Sign Assist / T
Freeze Frame Data
FREEZE FRAME DATA DESCRIPTION (a) Whenever a road sign assist system DTC is stored, the forward recognition camera stores the current vehicle state (ECU and sensor information) as freeze frame data. C
SEE MORE:
General maintenance
Listed below are the general maintenance
items that should be performed
at the intervals specified in
the "Warranty and Service Guide"
or "Owner's Manual Supplement".
It is recommended that any problem
you notice should be brought to
the attention of your Lexus dealer
or qualified service
Open in +B Circuit (C13AD)
DESCRIPTION The parking brake ECU assembly is supplied with power to operate the motor via the +B and +B2 terminals. DTC No. Detection Item DTC Detection Condition Trouble Area Memory Note C13AD Open in +B Circuit All of following conditions are met:
Power switch on (IG) or e
© 2016-2026 Copyright www.lexunx.com
