Lexus NX: Airbag ECU Malfunction (B1000)
DESCRIPTION
The airbag ECU assembly consists of a deceleration sensor, safing sensor, drive circuit, diagnosis circuit, ignition control, etc.
If the airbag ECU assembly receives signals from the deceleration sensor, it determines whether or not the SRS should be activated.
DTC B1000 is stored when a malfunction is detected in the airbag ECU assembly.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B1000 | Airbag ECU Malfunction | An airbag ECU assembly malfunction. | Airbag ECU assembly |
CAUTION / NOTICE / HINT
NOTICE:
After replacing the airbag ECU assembly, refer to initialization.
Click here .gif)
PROCEDURE
| 1. | CHECK DTC |
(a) Check for DTCs.
Click here
NOTICE:
If only DTC B1000 is output, do not clear the DTCs. Replace the airbag ECU assembly.
HINT:
If any DTCs other than DTC B1000 are also output, troubleshoot those DTCs first.
| DTC B1000 is output | .gif) | REPLACE AIRBAG ECU ASSEMBLY |
| DTC B1000 and other DTCs are output | | GO TO DIAGNOSTIC TROUBLE CODE CHART |
READ NEXT:
Front Airbag Sensor (RH) (B1610)
DESCRIPTION The front airbag sensor RH consists of a diagnostic circuit and frontal deceleration sensor, etc. If the airbag ECU assembly receives signals from the frontal deceleration sensor, it deter
Front Airbag Sensor Lost Communication (RH) (B1612,B1613)
DESCRIPTION The front airbag sensor RH circuit consists of the airbag ECU assembly and front airbag sensor RH. The front airbag sensor RH detects impacts to the vehicle and sends signals to the airbag
Front Airbag Sensor (LH) (B1615)
DESCRIPTION The front airbag sensor LH consists of a diagnostic circuit and frontal deceleration sensor, etc. If the airbag ECU assembly receives signals from the frontal deceleration sensor, it deter
SEE MORE:
Installation
INSTALLATION PROCEDURE 1. INSTALL NO. 2 EXHAUST MANIFOLD HEAT INSULATOR (a) Install the No. 2 exhaust manifold heat insulator with the 2 bolts. Torque: 13.5 N·m {138 kgf·cm, 10 ft·lbf} 2. INSTALL EXHAUST MANIFOLD CONVERTER SUB-ASSEMBLY (a) Install a new exhaust manifold to head gasket to the cyl
Operation Check
OPERATION CHECK CHECK SEAT HEATER (for Front) (a) Turn the power switch on (IG). (b) Check that the indicator illuminates and the surface of the front seat warms up, when the seat heater switch on the air conditioning control assembly is turned on. (c) Check that the front seat surface temperature c
