Lexus NX manuals

Lexus NX: Blind Spot Monitor Slave Module (C1AB7)

Lexus NX Service Manual / Audio & Visual & Telematics / Park Assist / Monitoring / Blind Spot Monitor System / Blind Spot Monitor Slave Module (C1AB7)

DESCRIPTION

This DTC is stored when the blind spot monitor sensor RH detects an internal malfunction.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

Note

C1AB7

Blind Spot Monitor Slave Module

The blind spot monitor sensor RH (slave) detects an internal malfunction

Blind spot monitor sensor RH

-

CAUTION / NOTICE / HINT

NOTICE:

When checking for DTCs, make sure that the blind spot monitor main switch (combination switch assembly) is on.

PROCEDURE

1.

CHECK DTC

(a) Clear the DTCs.

Click here

Body Electrical > Blind Spot Monitor Slave > Clear DTCs

(b) Recheck for DTCs and check if the same DTC is output again.

Body Electrical > Blind Spot Monitor Slave > Trouble Codes

OK:

DTC C1AB7 is not output.

OK

USE SIMULATION METHOD TO CHECK

NG

REPLACE BLIND SPOT MONITOR SENSOR RH

READ NEXT:

 Destination Information Undefined (C1AB8)

DESCRIPTION This DTC is stored when correct destination information is not sent from the main body ECU (multiplex network body ECU) and destination information cannot be confirmed after a blind spot m

 Blind Spot Monitor Master Module Beam Axis Inspection Incomplete (C1ABB)

DESCRIPTION This DTC is stored when a beam axis inspection has not been performed for the blind spot monitor sensor LH. HINT: This DTC is always stored after replacing a blind spot monitor sensor. The

 Blind Spot Monitor Slave Module Beam Axis Inspection Incomplete (C1ABC)

DESCRIPTION This DTC is stored when a beam axis inspection has not been performed for the blind spot monitor sensor RH. HINT: This DTC is always stored after replacing a blind spot monitor sensor. The

SEE MORE:

 Lost Communication with ECM / PCM "A" (U0100-U0142,U0155,U0163,U0293)

DESCRIPTION DTC No. Detection Item DTC Detection Condition Trouble Area Memory Note U0100 Lost Communication with ECM / PCM "A" No communication with ECM CAN communication system ECM - - U0131 Lost Communication with Power Steering Control Module No communi

 Readiness Monitor Drive Pattern

READINESS MONITOR DRIVE PATTERN PURPOSE OF READINESS TESTS The On-Board Diagnostic (OBD II) system is designed to monitor the performance of emission related components, and indicate any detected abnormalities using DTCs (Diagnostic Trouble Codes). Since various components need to be monitored du

© 2016-2026 Copyright www.lexunx.com