Lexus NX: Park Assist / Monitoring

READ NEXT:

 Blind Spot Monitor Main Switch

InspectionINSPECTION PROCEDURE 1. INSPECT COMBINATION SWITCH ASSEMBLY (BLIND SPOT MONITOR MAIN SWITCH) (a) Remove the combination switch assembly. Click here (b) Measure the resistance according

 Blind Spot Monitor Sensor

RemovalREMOVAL CAUTION / NOTICE / HINT NOTICE: Avoid any impact to the blind spot monitor sensor. Do not drop the blind spot monitor sensor. If it is dropped, replace it with a new one. PROCE

 Blind Spot Monitor System

SEE MORE:

 Short in P/T Squib (LH) Circuit (B1905-B1908)

DESCRIPTION The front pretensioner LH circuit consists of the airbag ECU assembly and front seat outer belt assembly LH. This circuit instructs the SRS to deploy when deployment conditions are met. These DTCs are stored when a malfunction is detected in the front pretensioner LH circuit. DTC No.

 Installation

INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. PROCEDURE 1. INSTALL ROOF DRIP SIDE FINISH MOULDING CLIP (w/o Roof Rack, except Glass Roof) NOTICE: It is only necessary to perform this procedure when

© 2016-2026 Copyright www.lexunx.com