Lexus NX: Dtc Check / Clear
DTC CHECK / CLEAR
DTC CHECK/CLEAR
(a) Check for DTCs.
(1) Connect the Techstream to the DLC3.
(2) Turn the power switch on (IG).
(3) Turn the Techstream on.
(4) Read the DTCs following the prompts on the Techstream screen. Enter the following menus: Chassis / ABS/VSC/TRAC / Trouble Codes.
Chassis > ABS/VSC/TRAC > Trouble Codes(5) Check the details of the DTCs.
Click here .gif)
(b) Clear the DTCs.
(1) Connect the Techstream to the DLC3.
(2) Turn the power switch on (IG).
(3) Turn the Techstream on.
(4) Enter the following menus: Chassis / ABS/VSC/TRAC / Trouble Codes.
(5) Press the DTC clear button.
Chassis > ABS/VSC/TRAC > Clear DTCsEND OF DTC CHECK/CLEAR
(a) Turn the power switch on (IG).
(b) Check that the ABS warning, brake warning / yellow (minor malfunction), slip indicator and brake hold operated indicator* lights go off when the power switch is turned on (READY).
-
*: The brake hold switch (integration control and panel assembly) is turned on under the following vehicle conditions.
-
Vehicle Conditions:
- The driver's door is closed.
- Driver's seat belt is fastened.
-
Vehicle Conditions:
READ NEXT:
Freeze Frame Data
FREEZE FRAME DATA FREEZE FRAME DATA/INFORMATION (a) Using the Techstream, check the vehicle condition (ECU, sensor) when the brake system operates or a DTC is output. (b) The freeze frame data that is
Fail-safe Chart
FAIL-SAFE CHART FAIL-SAFE FUNCTION OF CONTROL SYSTEM (a) When a malfunction is detected in the brake control system, the skid control ECU (brake booster with master cylinder assembly) turns the ABS wa
Data List / Active Test
DATA LIST / ACTIVE TEST DATA LIST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. Th
SEE MORE:
Installation
INSTALLATION PROCEDURE 1. INSTALL INTEGRATION CONTROL AND PANEL ASSEMBLY (a) Install the integration control and panel assembly to the rear upper console panel sub-assembly with the 2 screws. HINT: The locations labeled A in the illustration are tightened together with the shift position indicato
Front Lower Suspension Arm
ComponentsCOMPONENTS ILLUSTRATION *1 FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY LH *2 FRONT SUSPENSION CROSSMEMBER SUB-ASSEMBLY N*m (kgf*cm, ft.*lbf): Specified torque * For use with SST RemovalREMOVAL CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH an
