Lexus NX manuals

Lexus NX: Inspection

Lexus NX Service Manual / Brake / Brake Control / Dynamic Control Systems / Vsc Off Switch / Inspection

INSPECTION

PROCEDURE

1. INSPECT INTEGRATION CONTROL AND PANEL ASSEMBLY (VSC OFF SWITCH)

(a) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

4 (+) - 1 (GND)

Switch not pushed

10 kΩ or higher

Switch pushed

Below 1 Ω

If the result is not as specified, replace the integration control and panel assembly (VSC OFF switch).

*a

Component without harness connected

(Integration Control and Panel Assembly (VSC OFF Switch))

READ NEXT:

 Installation

INSTALLATION PROCEDURE 1. INSTALL INTEGRATION CONTROL AND PANEL ASSEMBLY (VSC OFF SWITCH) (a) Install the integration control and panel assembly (VSC OFF switch) to the upper rear console panel sub

 Brake System (other)

 Brake Booster

SEE MORE:

 Blind Spot Monitor Sensor Communication Stop Mode

DESCRIPTION Detection Item Symptom Trouble Area Blind Spot Monitor Sensor Communication Stop Mode Any of the following conditions are met: Communication stop for "Blind Spot Monitor Master" is indicated on the "Communication Bus Check" screen of the Techstream. Click here Commu

 Terminals Of Ecu

TERMINALS OF ECU CHECK DCM (TELEMATICS TRANSCEIVER) Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition I183-1 (+B) - I183-20 (E) Y - W-B Power source (+B) Power switch off 11 to 14 V I183-3 (SIG-) - I183-20 (E) G - W-B Ground Alway

© 2016-2026 Copyright www.lexunx.com