Lexus NX: Installation
INSTALLATION
PROCEDURE
1. INSTALL VEHICLE APPROACHING SPEAKER CONTROLLER
(a) Connect the connector.
(b) Attach the hook to install the vehicle approaching speaker controller.
NOTICE:
-
When installing the vehicle approaching speaker controller, take care not to damage it.
-
Do not reuse a vehicle approaching speaker controller that has been dropped or subjected to a strong shock.
-
Be sure to securely connect the vehicle approaching speaker controller connector.
(c) Install the bolt.
Torque:
8.0 N·m {82 kgf·cm, 71 in·lbf}
2. INSTALL ECU INTEGRATION BOX RH
Click here
3. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Click here
4. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY
Click here
5. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
Click here
6. INITIALIZATION AFTER RECONECTING AUXILIARY BATTERY TERMINAL
Click here
HINT:
When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.
Click here
7. INSTALL DECK FLOOR BOX LH
Click here
8. INSTALL REAR DECK FLOOR BOX
Click here
9. INSTALL NO. 3 DECK BOARD SUB-ASSEMBLY
Click here
READ NEXT:
REASSEMBLY CAUTION / NOTICE / HINT HINT:
A bolt without a torque specification is shown in the standard bolt chart.
Click here PROCEDURE 1. INSTALL CUSHION (a) Install the cushion. HINT: Use t
SEE MORE:
DESCRIPTION Based on the ECM signal, the power steering ECU assembly determines if the correct type of ECM is installed. DTC No. Detection Item DTC Detection Condition Trouble Area Warning Indicate Return-to-normal Condition Note C1567 Error in Matching of ECUs There is a syst
INSPECTION PROCEDURE 1. INSPECT SEPARATE TYPE FRONT SEAT CUSHION COVER LH *1 Connector A *2 Connector B *a Component without harness connected (Separate Type Front Seat Cushion Cover LH (Front Seat Cushion Heater)) (a) Check the separate type front seat cushion cover LH (front s
© 2016-2026 Copyright www.lexunx.com
