Lexus NX: Installation

INSTALLATION

CAUTION / NOTICE / HINT

NOTICE:

  • Do not replace the spiral cable with the battery connected and the power switch on (IG).
  • Do not rotate the spiral cable when the following conditions are met: 1) The steering wheel is removed, 2) the battery is connected, and 3) the power switch on (IG).
  • Ensure that the steering wheel assembly is installed and aligned straight when inspecting the steering sensor.
  • Do not remove the steering sensor from the spiral cable.

PROCEDURE

1. INSTALL SHIFT PADDLE SWITCH (TRANSMISSION SHIFT SWITCH ASSEMBLY)

(a) Engage the 6 guides to install the 2 shift paddle switches (transmission shift switch assemblies) with No. 1 switch wire to the steering wheel assembly.

(b) Connect the 2 shift paddle switch (transmission shift switch assembly) connectors to install the 2 shift paddle switches (transmission shift switch assemblies) to the No. 1 switch wire.

(c) Install the 2 shift paddle switches (transmission shift switch assemblies) to the steering wheel assembly with 4 new screws.

(d) Connect the No. 1 switch wire connector.

(e) Engage the guide to connect the No. 1 switch wire to the steering wheel assembly.

2. INSTALL STEERING PAD SWITCH ASSEMBLY

Click here

3. INSTALL CRUISE CONTROL MAIN SWITCH

Click here

4. INSTALL STEERING WHEEL ASSEMBLY

Click here

READ NEXT:

 Transmission Control Cable

 Components

COMPONENTS ILLUSTRATION *1 NO. 1 ENGINE UNDER COVER ASSEMBLY - - ILLUSTRATION *1 INVERTER BRACKET ASSEMBLY *2 INVERTER WATER PUMP WITH MOTOR ASSEMBLY *3 TRANSMISSION CONTR

 Removal

REMOVAL PROCEDURE 1. REMOVE NO. 1 SPEAKER WITH BOX ASSEMBLY (w/ ASC System) Click here 2. REMOVE REAR CONSOLE BOX ASSEMBLY (w/o ASC System) Click here 3. DISCONNECT TRANSMISSION CONTROL CABLE ASS

SEE MORE:

 IG Power Source Circuit

DESCRIPTION When the power switch is turned on (IG), the IG power source circuit supplies positive (+) voltage to the multiplex tilt and telescopic ECU. The multiplex tilt and telescopic ECU also receives power switch signals via this circuit. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: Inspect

 Sensor (Motor) Failure (B2341,B2344)

DESCRIPTION When the sliding roof drive gear sub-assembly (sliding roof ECU) detects a motor malfunction and the sliding roof operation is stopped, DTC B2341 is stored. When the sliding roof drive gear sub-assembly (sliding roof ECU) detects a gear position malfunction and the sliding roof operation

© 2016-2026 Copyright www.lexunx.com