Lexus NX: On-vehicle Inspection
ON-VEHICLE INSPECTION
CAUTION / NOTICE / HINT
CAUTION:
Be sure to follow the correct removal and installation procedures of the front airbag sensors.
PROCEDURE
1. INSPECT FRONT AIRBAG SENSOR (for Vehicle not Involved in Collision)
(a) Perform a diagnostic system check.
Click here .gif)
2. INSPECT FRONT AIRBAG SENSOR (Vehicle Involved in Collision and Airbag not Deployed)
(a) Perform a diagnostic system check.
Click here
(b) Visually check the front airbag sensors for defects if the front bumper of the vehicle or the area around the bumper is damaged.
(1) The defects are as follows:
- Cracks on the sensor housing
- Dents on the sensor housing
- Chips on the sensor housing
- Cracks or other damage to the connector
- Damage to the serial number
OK:
No defects are found.
HINT:
If any of the defects is found, replace the front airbag sensor with a new one.
3. INSPECT FRONT AIRBAG SENSOR (Vehicle Involved in Collision and Airbag is Deployed)
(a) When airbags have deployed as the result of a collision, be sure to replace all front airbag sensors in the damaged areas (anywhere in need of repair).
(b) Visually check the front airbag sensors in undamaged areas for defects.
(1) The defects are as follows:
- Cracks on the sensor housing
- Dents on the sensor housing
- Chips on the sensor housing
- Cracks or other damage to the connector
- Damage to the serial number
OK:
No defects are found.
HINT:
If any of the defects is found or a front airbag sensor has detected a major collision, replace the front airbag sensor with a new one.
READ NEXT:
Removal
REMOVAL CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. REMOVE NO. 3 DECK BOARD SUB-ASSEMBLY Click her
Installation
INSTALLATION CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. INSTALL FRONT AIRBAG SENSOR LH (a) Check
SEE MORE:
Front Passenger Side Door Entry Lock Function does not Operate
DESCRIPTION If the entry lock function does not operate for the front passenger door only, but the entry unlock function operates, the request code is being transmitted properly from the for passenger door. In this case, there may be a problem related to the lock sensor (connection between the certi
Removal
REMOVAL CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. REMOVE TONNEAU COVER ASSEMBLY Click here 2. REMOVE DECK BOARD ASSEMBLY Click here 3. REMOVE NO. 3 DECK BOARD SUB-ASSEMBLY Click here
