Lexus NX: On-vehicle Inspection
ON-VEHICLE INSPECTION
CAUTION / NOTICE / HINT
NOTICE:
- When the brake pedal is first depressed after replacing the brake pads or pushing back the disc brake piston, DTC C1214 may be output. As there is no malfunction, clear the DTC.
- While the auxiliary battery is connected, even if the power switch is off, the brake control system activates when the brake pedal is depressed or the door courtesy switch is turned on. Therefore, even if only brake shoes are to be removed and installed, be sure to perform the Disable Brake Control procedure and disconnect the cable from the negative (-) terminal of the auxiliary battery before beginning work.
HINT:
- Use the same procedure for the RH and LH sides.
- The procedure listed below is for the LH side.
PROCEDURE
1. PRECAUTION
NOTICE:
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notice before proceeding with work.
(Click here .gif)
)
2. DISABLE BRAKE CONTROL
Click here
3. REMOVE FRONT WHEEL
Click here
4. DISCONNECT FRONT DISC BRAKE CALIPER ASSEMBLY LH
Click here
5. REMOVE FRONT DISC
Click here
6. INSPECT FRONT AXLE HUB BEARING LOOSENESS
(a) Using a dial indicator, check for looseness near the center of the front axle hub sub-assembly.
Maximum:
0.05 mm (0.00197 in.)
NOTICE:
Make sure that the dial indicator is set perpendicular to the measurement surface.
If the looseness is more than the maximum, replace the front axle hub sub-assembly.
7. INSPECT FRONT AXLE HUB RUNOUT
(a) Using a dial indicator, check for runout on the surface of the front axle hub sub-assembly outside the front hub bolt.
Maximum:
0.05 mm (0.00197 in.)
NOTICE:
Make sure that the dial indicator is set perpendicular to the measurement surface.
If the runout is more than the maximum, replace the front axle hub sub-assembly.
8. INSTALL FRONT DISC
Click here
9. CONNECT FRONT DISC BRAKE CALIPER ASSEMBLY LH
Click here
10. INSTALL FRONT WHEEL
Click here
11. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
(a) Connect the cable to the negative (-) auxiliary battery terminal and tighten the nut.
Torque:
5.4 N·m {55 kgf·cm, 48 in·lbf}
READ NEXT:
Removal
REMOVAL CAUTION / NOTICE / HINT NOTICE:
When the brake pedal is first depressed after replacing the brake pads or pushing back the disc brake piston, DTC C1214 may be output. As there is no malfunc
Installation
INSTALLATION CAUTION / NOTICE / HINT NOTICE:
When the brake pedal is first depressed after replacing the brake pads or pushing back the disc brake piston, DTC C1214 may be output. As there is no ma
SEE MORE:
Rear Door LH Entry Lock and Unlock Functions do not Operate
DESCRIPTION If the entry lock and unlock functions do not operate for the rear door LH only, the request code may not be being transmitted from the rear door LH or the rear door outside handle assembly LH (touch sensor) may be malfunctioning. If the entry functions for other doors operate properly,
Removal
REMOVAL CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. REMOVE OUTER MIRROR LH (a) Push the upper part of the mirror surface and tilt it. (b) Apply protective tape to the areas shown in the illustrat
