Lexus NX: Installation
INSTALLATION
PROCEDURE
1. INSTALL VEHICLE SOUND SWITCH
(a) Attach the 2 claws to install the vehicle sound switch.
2. INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL
Click here .gif)
3. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Click here
4. INSTALL NO. 1 SWITCH HOLE BASE
Click here
5. INSTALL NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY
Click here
6. INSTALL INSTRUMENT SIDE PANEL LH
Click here
7. INSTALL UPPER NO. 2 CONSOLE PANEL GARNISH
Click here
8. INSTALL UPPER REAR CONSOLE PANEL
Click here
9. INSTALL CONSOLE ARMREST ASSEMBLY
Click here
READ NEXT:
Parts Location
PARTS LOCATION ILLUSTRATION *1 VEHICLE SOUND SWITCH *2 STEREO COMPONENT EQUALIZER ASSEMBLY *3 NO. 1 SPEAKER ASSEMBLY WITH BOX *4 HYBRID VEHICLE CONTROL ECU *5 MAIN BODY ECU (
System Diagram
SYSTEM DIAGRAM Communication Table Sender Receiver Signal Line Brake booster with master cylinder assembly (skid control ECU) Stereo component equalizer assembly Vehicle speed signal
SEE MORE:
Removal
REMOVAL PROCEDURE 1. REMOVE FUEL TANK ASSEMBLY Click here 2. DISCONNECT FUEL TANK MAIN TUBE SUB-ASSEMBLY (a) Remove the tube joint clip, then disconnect the fuel tank main tube sub-assembly from the fuel suction plate sub-assembly. NOTICE:
Remove dirt or foreign objects on the fuel tube j
Terminals Of Ecu
TERMINALS OF ECU CHECK WINDSHIELD WIPER RELAY ASSEMBLY (w/ Rain Sensor) (a) Disconnect the I56 windshield wiper relay assembly connector. (b) Measure the voltage and resistance according to the value(s) in the table below. HINT: Measure the values on the wire harness side with the connector disconn
© 2016-2026 Copyright www.lexunx.com
