Lexus NX manuals

Lexus NX: Parking Brake System

Lexus NX Service Manual / Brake / Parking Brake / Parking Brake System

Precaution

PRECAUTION

CAUTION:

Perform each part replacement carefully, as mistakes could affect the brake system performance and lead to driving problems. When replacing a part, replace with the same part or equivalent.

NOTICE:

  • As these procedures may affect the SRS airbags, it is necessary to read the SRS airbag precautions.

    Click here

  • While the battery is connected, even if the power switch is off, the brake control system activates when the brake pedal is depressed with the door courtesy switch on. Therefore during servicing of the brake system components, do not operate the brake pedal and open/close the doors while the battery is connected.
  • Do not operate the electric parking brake switch with the battery connected, unless otherwise instructed in the procedures.
  • Make sure that the electric parking brake AUTO switch is off. This is necessary to prevent the system from activating when the shift lever is moved.
  • After turning the power switch off, thee parking brake ECU assembly and parking brake actuator assembly operate for 20 seconds. If a connector is disconnected within this period, a DTC may be output.
  • When servicing the brake system, make sure its parts and surrounding parts are clean.

Problem Symptoms Table

PROBLEM SYMPTOMS TABLE

HINT:

Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.

Parking Brake System

Symptom

Suspected Area

See page

Parking brake drags

Electric parking brake actuator assembly

READ NEXT:

 Drivetrain

 Axle And Differential

 Axle System

SEE MORE:

 Front Wheel Speed Sensor Malfunction (C164D)

DESCRIPTION This DTC are stored when the parking assist ECU receives a wheel speed sensor (front speed sensor RH or front speed sensor LH) abnormality signal from the electronically controlled brake system via CAN communication. DTC No. Detection Item DTC Detection Condition Trouble Area

 Freeze Frame Data

FREEZE FRAME DATA FREEZE FRAME DATA (a) Whenever a DTC is detected, the blind spot monitor sensor stores the current vehicle (sensor) state as Freeze Frame Data. CHECK FREEZE FRAME DATA (a) Connect the Techstream to the DLC3. (b) Turn the power switch on (IG). (c) Turn the blind spot monitor main sw

© 2016-2025 Copyright www.lexunx.com