Lexus NX: Sound Quality is Bad Only when Disc is Played (Volume is Too Low)
CAUTION / NOTICE / HINT
NOTICE:
When replacing the radio receiver assembly, always replace it with a new one.
If a radio receiver assembly which was installed to another vehicle is used, the following may occur:
- A communication malfunction DTC may be stored.
- The radio receiver assembly may not operate normally.
HINT:
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Navigation System.
Click here .gif)
PROCEDURE
| 1. | REPLACE DISC AND RECHECK |
(a) Replace the disc with a known good one and check that the malfunction disappears.
OK:
Malfunction disappears.
| OK | .gif) | END |
|
.gif)
| 2. | CHECK NOISE CONDITION |
(a) Check that noise is output from the speakers when a disc is inserted and is being read.
OK:
Noise is output.
| OK | | REPLACE STEREO COMPONENT AMPLIFIER ASSEMBLY |
| NG | | REPLACE RADIO RECEIVER ASSEMBLY |
READ NEXT:
Disc cannot be Inserted or is Ejected Right After Insertion
CAUTION / NOTICE / HINT NOTICE: When replacing the radio receiver assembly, always replace it with a new one. If a radio receiver assembly which was installed to another vehicle is used, the following
Disc cannot be Ejected
CAUTION / NOTICE / HINT NOTICE: When replacing the radio receiver assembly, always replace it with a new one. If a radio receiver assembly which was installed to another vehicle is used, the following
CD/DVD Sound Skips
CAUTION / NOTICE / HINT NOTICE: When replacing the radio receiver assembly, always replace it with a new one. If a radio receiver assembly which was installed to another vehicle is used, the following
SEE MORE:
Components
COMPONENTS ILLUSTRATION *1 OUTSIDE MOULDING RETAINER *2 REAR DOOR LOWER OUTSIDE MOULDING SUB-ASSEMBLY LH *3 REAR DOOR NO. 2 WEATHERSTRIP LH *4 REAR DOOR REAR UPPER OUTSIDE MOULDING LH *5 HOLE COVER - - ● Non-reusable part - - ILLUSTRATION *1 REAR DO
On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY (a) Connect the Techstream to the DLC3. (b) Turn the Techstream on. (c) Put the engine in inspection mode (maintenance mode). Click here (d) Start the engine. (e) Warm up the engine. (f) Enter the following menus
