Lexus NX: Tire / Wheel

READ NEXT:

 Tire And Wheel

RemovalREMOVAL PROCEDURE 1. REMOVE WHEEL ASSEMBLY (a) Loosen the axle hub nuts approximately 90°. (b) Lift up the vehicle and remove the axle hub nuts and wheel assembly. InstallationINSTALLATION P

 Tire And Wheel System

 How To Proceed With Troubleshooting

PROCEDURE 1. CHECK TIRE AND WHEEL SYSTEM DIAGNOSIS OF IRREGULAR TIRE WEAR GO TO STEP 11 DIAGNOSIS OF TIRE VIBRATION 2. TIGHTEN WHEEL NUTS NEXT

SEE MORE:

 Removal

REMOVAL PROCEDURE 1. REMOVE FRONT BUMPER ASSEMBLY Click here 2. REMOVE NO. 3 ENGINE ROOM WIRE Click here 3. REMOVE CLEARANCE LIGHT ASSEMBLY LH (a) for LED Type Side Turn Signal Light: Click here (b) for Bulb Type Side Turn Signal Light: Click here 4. REMOVE CLEARANCE LIGHT ASSEMBLY RH HINT:

 Check Bus 2 Line for Short to GND

DESCRIPTION There may be a short circuit between one of the CAN bus wire and GND when there is no resistance between terminal 18 (CA4H) of the central gateway ECU (network gateway ECU) and terminal 4 (CG) of the DLC3, or terminal 17 (CA4L) of the central gateway ECU (network gateway ECU) and termina

© 2016-2024 Copyright www.lexunx.com