ADJUSTMENT CAUTION / NOTICE / HINT NOTICE: If a wheel alignment has been performed, or if suspension or underbody components have been removed/installed or replaced, be sure to perform the following i
AdjustmentADJUSTMENT CAUTION / NOTICE / HINT NOTICE: If a wheel alignment has been performed, or if suspension or underbody components have been removed/installed or replaced, be sure to perform the
REASSEMBLY CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. INSTALL NO. 1 MOULDING TAPE (a) Clean the No. 1 moulding tape installation surface with a non-residue solvent. (b) Apply primer to the No. 1 mo
INSPECTION PROCEDURE 1. INSPECT AIR CONDITIONING THERMISTOR ASSEMBLY (HUMIDITY SENSOR) (a) for Glass temperature sensor: (1) Measure the resistance according to the value(s) in the table below. *a Component without harness connected (Air Conditioning Thermistor Assembly (Glass Temperature Sens