Lexus NX: Front Wheel Alignment
READ NEXT:
Adjustment
ADJUSTMENT CAUTION / NOTICE / HINT NOTICE: If a wheel alignment has been performed, or if suspension or underbody components have been removed/installed or replaced, be sure to perform the following i
Rear Wheel Alignment
AdjustmentADJUSTMENT CAUTION / NOTICE / HINT NOTICE: If a wheel alignment has been performed, or if suspension or underbody components have been removed/installed or replaced, be sure to perform the
SEE MORE:
Steering Angle Sensor Initialization Incomplete (C1439,C1445)
DESCRIPTION The skid control ECU (brake booster with master cylinder assembly) acquires the steering sensor zero point every time the power switch is turned on (IG) and the vehicle is driven at 35 km/h (22 mph) or more for approximately 5 seconds. The ECU also stores previous zero points. DTCs C1439
Removal
REMOVAL PROCEDURE 1. REMOVE STEERING PAD Click here 2. REMOVE CRUISE CONTROL MAIN SWITCH Click here 3. REMOVE STEERING PAD SWITCH ASSEMBLY (a) Disconnect the connector from the spiral cable with sensor sub-assembly. (b) Remove the 2 screws. (c) Detach the 3 guide pins and 4 cla
© 2016-2025 Copyright www.lexunx.com
