Lexus NX: Assist Map Number Mismatch (C1582)

DESCRIPTION

When an incorrect hybrid vehicle control ECU, incorrect skid control ECU or incorrect main body ECU is installed after the assist map has been written in the power steering ECU assembly, DTC C1582 is stored because the data does not match the vehicle specifications.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

Warning Indicate

Return-to-normal Condition

Note

C1582

Assist Map Number Mismatch

Assist map number mismatch

  • CAN communication system
  • Incorrect hybrid vehicle control ECU
  • Incorrect skid control ECU (brake booster with master cylinder assembly)
  • Incorrect main body ECU (multiplex network body ECU)
  • Power steering ECU assembly

Off

Power switch on (IG) again

-

CAUTION / NOTICE / HINT

NOTICE:

  • If the power steering ECU assembly has been replaced, perform assist map writing and torque sensor zero point calibration.

    Click here

  • If the main body ECU (multiplex network body ECU) is replaced, refer to Registration.

    Click here

PROCEDURE

1.

CHECK CAN COMMUNICATION SYSTEM

(a) Check for DTCs.

Click here

CAN communication system DTC is output.

GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING)

CAN communication system DTC is not output.

2.

CHECK RELATED PART

(a) Check if any of the parts listed below have been replaced with an incorrect part in the past.

Related Part

Hybrid vehicle control ECU

Main body ECU (multiplex network body ECU)

Skid control ECU (brake booster with master cylinder assembly)

NOTICE:

When removing a related part to check it, be sure to follow the appropriate procedures and precautions.

  • Hybrid vehicle control ECU

    Click here

  • Main body ECU (multiplex network body ECU)

    Click here

  • Skid control ECU (brake booster with master cylinder assembly)

    Click here

HINT:

When DTC C1582 is output when parts have not been exchanged, replace the power steering ECU assembly as it may have an internal malfunction.

All installed related parts have correct part number

REPLACE POWER STEERING ECU ASSEMBLY

Part with incorrect part number is installed

REPLACE RELATED PART WITH PART THAT HAS CORRECT PART NUMBER

READ NEXT:

 Lost Communication with Brake System Control Module (U0129,U0293,U1104)

DESCRIPTION The power steering ECU assembly receives signals from the hybrid vehicle control ECU, skid control ECU(brake booster with master cylinder assembly) and forward recognition camera via the C

 Power Steering Warning Light Circuit

DESCRIPTION The power steering ECU is connected to the combination meter via CAN communication. If any of the following conditions are detected, the power steering warning light remains on. The cir

 Steering Column

SEE MORE:

 PTC Heater Circuit

DESCRIPTION The air conditioning amplifier assembly sends operation signals to the PTC heater relays when quick heater assembly operation conditions are met. Based on the signals from the air conditioning amplifier assembly, the PTC heater relays turn on, and power is supplied to the quick heater as

 Diagnostic Trouble Code Chart

DIAGNOSTIC TROUBLE CODE CHART Vehicle Proximity Notification System DTC No. Detection Item Link B1350 Speaker Circuit U0129 Lost Communication with Brake System Control Module U0140 Lost Communication with Body Control Module U0293 Lost Communication wit

© 2016-2025 Copyright www.lexunx.com