Lexus NX: Components
COMPONENTS
ILLUSTRATION
| *1 | FOG LIGHT ASSEMBLY LH | - | - |
ILLUSTRATION
| *1 | FOG LIGHT GASKET | *2 | FOG LIGHT LENS LH |
| *3 | FOG LIGHT UNIT LH | *4 | PIVOT COLLAR |
| ● | Non-reusable part | - | - |
READ NEXT:
Removal
REMOVAL CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure described below is for the LH side.
PROCEDURE 1. REMOVE FRONT BUMPER ASSEMBLY Click here 2
Disassembly
DISASSEMBLY PROCEDURE 1. PRECAUTION NOTICE:
Be sure to read Precaution thoroughly before servicing.
Click here
Handle components indoors as much as possible to prevent foreign matter from enter
Inspection
INSPECTION PROCEDURE 1. INSPECT FOG LIGHT ASSEMBLY LH (a) Apply battery voltage to the connector and check the light illumination condition. OK: Battery Connection Specified Condition Pos
SEE MORE:
Reassembly
REASSEMBLY PROCEDURE 1. INSTALL PACKING (a) Install 3 new packings. 2. INSTALL REAR SPOILER NO. 2 PROTECTOR HINT: When installing the rear spoiler No. 2 protector, heat the rear spoiler assembly using a heat light. Standard: Item Temperature Rear Spoiler Assembly 20 to 30°C (68 to 86°F
Power Source Mode does not Change to ON (READY)
DESCRIPTION When the electrical key transmitter sub-assembly is in the cabin and the power switch is pressed, the certification ECU (smart key ECU assembly) receives a signal and changes the power source mode. In addition, when the power switch is pressed with the shift lever in P and the brake peda
© 2016-2026 Copyright www.lexunx.com
