Lexus NX: Lost Communication with Brake System Control Module (U0129,U0293,U1104)
DESCRIPTION
The power steering ECU assembly receives signals from the hybrid vehicle control ECU, skid control ECU(brake booster with master cylinder assembly) and forward recognition camera via the CAN communication system.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Warning Indicate | Return-to-normal Condition | Note |
|---|---|---|---|---|---|---|
| U0129 | Lost Communication with Brake System Control Module | Lost communication with skid control ECU (brake booster with master cylinder assembly) |
| On | After normal confirmation | - |
| U0293 | Lost Communication with Hybrid Control Module | Lost communication with hybrid vehicle control ECU |
| On | After normal confirmation | - |
| U1104 | Lost Communication with Driving Support ECU | Lost communication with Forward recognition camera |
| Off | After normal confirmation | - |
PROCEDURE
| 1. | GO TO CAN COMMUNICATION SYSTEM |
(a) Go to CAN Communication System.
Click here .gif)
| NEXT | .gif) | END |
READ NEXT:
Power Steering Warning Light Circuit
DESCRIPTION The power steering ECU is connected to the combination meter via CAN communication. If any of the following conditions are detected, the power steering warning light remains on.
The cir
SEE MORE:
Removal
REMOVAL PROCEDURE 1. REMOVE DECK BOARD ASSEMBLY Click here 2. REMOVE NO. 3 DECK BOARD SUB-ASSEMBLY Click here 3. REMOVE REAR DECK FLOOR BOX Click here 4. REMOVE DECK FLOOR BOX LH Click here 5. PRECAUTION CAUTION: Be sure to read Precaution thoroughly before serving. Click here NOTICE: Afte
Slave Module Horizontal Axis Misalignment (C1AC2)
DESCRIPTION This DTC is stored when the angle of the blind spot monitor sensor RH deviates more than the allowable range from the horizontal axis. HINT: If a drum tester such as a speedometer tester, brake/speedometer combination tester or chassis dynamometer is used with the blind spot monitor main
