Lexus NX: Steering
Lexus NX Service Manual / Steering
- Power Assist Systems
- Power Steering Ecu (for Manual Tilt And Manual Telescopic Steering Column)
- Power Steering Ecu (for Power Tilt And Power Telescopic Steering Column)
- Power Steering System (for Manual Tilt And Manual Telescopic Steering Column)
- Power Steering System (for Power Tilt And Power Telescopic Steering Column)
- Steering Column
- Heated Steering Wheel Controller (w/ Steering Wheel Vibration)
- Heated Steering Wheel System
- Multiplex Tilt And Telescopic Ecu
- Power Tilt And Power Telescopic Steering Column System
- Steering Column Assembly (for Manual Tilt And Manual Telescopic Steering Column)
- Steering Column Assembly (for Power Tilt And Power Telescopic Steering Column)
- Steering Heater Switch
- Steering Lock System
- Steering Pad Switch
- Steering System
- Steering Wheel
- Tilt And Telescopic Manual Switch
- Steering Gear / Linkage
READ NEXT:
Power Steering Ecu (for Manual Tilt And Manual Telescopic Steering Column)
ComponentsCOMPONENTS ILLUSTRATION *1 ELECTRIC POWER STEERING COLUMN SUB-ASSEMBLY *2 POWER STEERING ECU ASSEMBLY *3 POWER STEERING ECU PROTECTOR *4 ECU WIRE SUB-ASSEMBLY N*m
SEE MORE:
Installation
INSTALLATION PROCEDURE 1. INSTALL FRONT DRIVE SHAFT HOLE SNAP RING LH (a) Install a new front drive shaft hole snap ring LH. NOTICE:
Do not damage the spline of the front drive inboard joint assembly LH.
Front drive shaft hole snap ring LH should be installed completely.
2. INSTALL FRONT DRI
Dtc Check / Clear
DTC CHECK / CLEAR CHECK FOR DTC (a) Turn the power switch off. (b) Connect the Techstream to the DLC3. (c) Turn the power switch on (IG). (d) Turn the Techstream on. (e) Enter the following menus: Body Electrical / Back Door / Trouble Codes. (f) Check for DTCs. Click here Body Electrical > Back
© 2016-2026 Copyright www.lexunx.com
