Lexus NX: Blind Spot Monitor Master Module (C1AB6)

DESCRIPTION

This DTC is stored when the blind spot monitor sensor LH detects an internal malfunction.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

Note

C1AB6

Blind Spot Monitor Master Module

The blind spot monitor sensor LH (master) detects an internal malfunction.

Blind spot monitor sensor LH

-

CAUTION / NOTICE / HINT

NOTICE:

When checking for DTCs, make sure that the blind spot monitor main switch (combination switch assembly) is on.

PROCEDURE

1.

CHECK DTC

(a) Clear the DTCs.

Click here

Body Electrical > Blind Spot Monitor Master > Clear DTCs

(b) Recheck for DTCs and check if the same DTC is output again.

Body Electrical > Blind Spot Monitor Master > Trouble Codes

OK:

DTC C1AB6 is not output.

OK

USE SIMULATION METHOD TO CHECK

NG

REPLACE BLIND SPOT MONITOR SENSOR LH

READ NEXT:

 Blind Spot Monitor Slave Module (C1AB7)

DESCRIPTION This DTC is stored when the blind spot monitor sensor RH detects an internal malfunction. DTC No. Detection Item DTC Detection Condition Trouble Area Note C1AB7 Blind Spot

 Destination Information Undefined (C1AB8)

DESCRIPTION This DTC is stored when correct destination information is not sent from the main body ECU (multiplex network body ECU) and destination information cannot be confirmed after a blind spot m

 Blind Spot Monitor Master Module Beam Axis Inspection Incomplete (C1ABB)

DESCRIPTION This DTC is stored when a beam axis inspection has not been performed for the blind spot monitor sensor LH. HINT: This DTC is always stored after replacing a blind spot monitor sensor. The

SEE MORE:

 Electronic key battery

Replace the battery with a new one if it is depleted. ■When the card key battery needs to be replaced (if equipped) The battery for the card key is available only at Lexus dealers. Your Lexus dealer can replace the battery for you. ■If the electronic key battery is depleted The followi

 System Diagram

SYSTEM DIAGRAM *1 ECM *2 Engine Coolant Temperature Sensor *3 Air Fuel Ratio Sensor (for Bank 1 Sensor 1) *4 Heated Oxygen Sensor (for Bank 1 Sensor 2) *5 Crankshaft Position Sensor *6 Intake Manifold *7 Manifold Absolute Pressure Sensor *8 EGR Valve Assembly

© 2016-2026 Copyright www.lexunx.com