Lexus NX manuals

Lexus NX: Components

Lexus NX Service Manual / Steering / Steering Column / Heated Steering Wheel Controller (w/ Steering Wheel Vibration) / Components

COMPONENTS

ILLUSTRATION

*1

CRUISE CONTROL MAIN SWITCH

*2

SHIFT PADDLE SWITCH (TRANSMISSION SHIFT SWITCH ASSEMBLY)

*3

STEERING PAD SWITCH ASSEMBLY

*4

STEERING WHEEL ASSEMBLY

*5

STEERING WHEEL HEATER CONTROL ASSEMBLY

*6

SWITCH NO. 1 WIRE

N*m (kgf*cm, ft.*lbf): Specified torque

●

Non-reusable part

★

Precoated part

-

-

READ NEXT:

 Removal

REMOVAL PROCEDURE 1. REMOVE STEERING WHEEL ASSEMBLY Click here 2. REMOVE STEERING PAD SWITCH ASSEMBLY Click here 3. REMOVE CRUISE CONTROL MAIN SWITCH Click here 4. REMOVE SHIFT PADDLE SWITCH (TR

 Installation

INSTALLATION PROCEDURE 1. INSTALL STEERING WHEEL HEATER CONTROL ASSEMBLY (a) Connect the connector to the steering wheel heater control assembly. (b) Install the steering wheel heater control assembly

 Heated Steering Wheel System

SEE MORE:

 Operation Check

OPERATION CHECK CHECK SLIDING ROOF NOTICE: If the negative battery terminal is disconnected under the following conditions, initialization of the sliding roof drive gear sub-assembly may not be completed. In this case, perform initialization. Within 2 seconds after roof glass operation stops.

 System Description

SYSTEM DESCRIPTION GENERAL (a) This system uses ultrasonic sensors to detect any obstacles at the corners and the rear of the vehicle. The system then informs the driver of the distance between the sensors and an obstacle as well as their positions by indicating them on the multi-information display

© 2016-2026 Copyright www.lexunx.com