Lexus NX: Removal

Lexus NX Service Manual / Steering / Steering Column / Heated Steering Wheel Controller (w/ Steering Wheel Vibration) / Removal

REMOVAL

PROCEDURE

1. REMOVE STEERING WHEEL ASSEMBLY

Click here

2. REMOVE STEERING PAD SWITCH ASSEMBLY

Click here

3. REMOVE CRUISE CONTROL MAIN SWITCH

Click here

4. REMOVE SHIFT PADDLE SWITCH (TRANSMISSION SHIFT SWITCH ASSEMBLY)

Click here

5. REMOVE STEERING WHEEL HEATER CONTROL ASSEMBLY

(a) Disengage the guide to remove the wire harness from the lower steering wheel cover.

(b) Disconnect the 2 connectors.

*1	Heater Thermistor

(d) Disengage the 2 claws of the lower steering wheel boss cover.

HINT:

Do not remove the lower steering wheel boss cover from the steering wheel sub-assembly. Loosen the lower steering boss cover.

NOTICE:

If the heater thermistor comes off the lower steering wheel cover, replace the steering wheel assembly.

(e) Remove the 2 screws.

(f) Move the steering wheel heater control assembly until it reaches a position where the connecter can be disconnected.

(g) Disengage the connector to remove the steering wheel heater control assembly from the lower steering wheel cover.

SEE MORE:

Registered Device cannot be Deleted

PROCEDURE 1. DELETE OPERATION (a) Check if a registered portable player can be deleted normally. OK: Registered portable player can be deleted normally. OK END NG PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

Brake System (C1A50)

DESCRIPTION When an electronically controlled brake system malfunction signal sent from the brake booster with master cylinder assembly (skid control ECU) is detected by the clearance warning ECU assembly, DTC C1A50 is stored. DTC No. Detection Item DTC Detection Condition Trouble Area

Lexus NX: Removal

READ NEXT:

Installation

Heated Steering Wheel System

Precaution

SEE MORE:

Registered Device cannot be Deleted

Brake System (C1A50)