Lexus NX: Installation
INSTALLATION
PROCEDURE
1. INSTALL STEERING WHEEL HEATER CONTROL ASSEMBLY
(a) Connect the connector to the steering wheel heater control assembly.
(b) Install the steering wheel heater control assembly to the lower steering wheel boss cover with the 2 screws.
NOTICE:
If the heater thermistor comes off the lower steering wheel cover, replace the steering wheel assembly.
(c) Engage the 2 claws to install the lower steering wheel boss cover to the steering wheel assembly.
NOTICE:
If the heater thermistor comes off the lower steering wheel cover, replace the steering wheel assembly.
(d) Connect the 2 connectors to the steering wheel heater control assembly.
(e) Engage the guide to install the wire harness to the lower steering wheel cover.
2. INSTALL SHIFT PADDLE SWITCH (TRANSMISSION SHIFT SWITCH ASSEMBLY)
Click here .gif)
3. INSTALL CRUISE CONTROL MAIN SWITCH
Click here
4. INSTALL STEERING PAD SWITCH ASSEMBLY
Click here
5. PLACE FRONT WHEELS FACING STRAIGHT AHEAD
6. ADJUST SPIRAL CABLE
Click here
7. INSTALL STEERING WHEEL ASSEMBLY
Click here
READ NEXT:
Precaution
PRECAUTION PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL NOTICE: When disconnecting and reconnecting the auxiliary battery. Click here HINT: When disconnecting and reco
Parts Location
PARTS LOCATION ILLUSTRATION *1 NO. 2 COMBINATION SWITCH ASSEMBLY - STEERING HEATER SWITCH *2 STEERING WHEEL ASSEMBLY - STEERING WHEEL HEATER UNIT *3 INSTRUMENT PANEL JUNCTION BLOCK ASS
SEE MORE:
Removal
REMOVAL PROCEDURE 1. REMOVE INSTRUMENT PANEL FINISH PLATE 2. REMOVE MULTI-DISPLAY ASSEMBLY WITH BRACKET Click here 3. REMOVE CONSOLE ARMREST ASSEMBLY Click here 4. REMOVE UPPER REAR CONSOLE PANEL Click here 5. REMOVE UPPER NO. 1 CONSOLE PANEL GARNISH Click here 6. REMOVE UPPER NO. 2 CONS
Front Airbag Sensor (RH) (B1610)
DESCRIPTION The front airbag sensor RH consists of a diagnostic circuit and frontal deceleration sensor, etc. If the airbag ECU assembly receives signals from the frontal deceleration sensor, it determines whether the SRS should be activated. DTC B1610 is stored when a malfunction is detected in the
