Lexus NX: Components

COMPONENTS

ILLUSTRATION

*1

DECK FLOOR BOX LH

*2

NO. 3 DECK BOARD SUB-ASSEMBLY

*3

REAR DECK FLOOR BOX

*4

AUXILIARY BATTERY NEGATIVE TERMINAL

N*m (kgf*cm, ft.*lbf): Specified torque

-

-

ILLUSTRATION

*1

CURTAIN SHIELD AIRBAG ASSEMBLY LH

*2

CLIP

*3

CURTAIN SHIIELD AIRBAG SPACER

-

-

N*m (kgf*cm, ft.*lbf): Specified torque

●

Non-reusable part

READ NEXT:

 On-vehicle Inspection

ON-VEHICLE INSPECTION CAUTION / NOTICE / HINT CAUTION: Be sure to follow the correct removal and installation procedures of the curtain shield airbag assemblies. PROCEDURE 1. INSPECT CURTAIN SHIELD AI

 Installation

INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. PROCEDURE 1. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY LH

 Front Airbag Sensor

SEE MORE:

 Terminals Of Ecu

TERMINALS OF ECU CHECK MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY (a) Disconnect the M10 multiplex network master switch assembly connector. (b) Measure the voltage and resistance according to the value(s) in the table below. HINT: Measure the values on the wire harness side with the connector discon

 Installation

INSTALLATION PROCEDURE 1. INSTALL OCCUPANT DETECTION ECU (a) Attach the claw to install the occupant detection ECU. NOTICE: If the occupant detection ECU has been dropped, or there are any cracks, dents or other defects in the case or connector, replace the occupant detection ECU with a new one. (b)

© 2016-2026 Copyright www.lexunx.com