Lexus NX: On-vehicle Inspection
ON-VEHICLE INSPECTION
CAUTION / NOTICE / HINT
CAUTION:
Be sure to follow the correct removal and installation procedures of the curtain shield airbag assemblies.
PROCEDURE
1. INSPECT CURTAIN SHIELD AIRBAG ASSEMBLY (for Vehicle not Involved in Collision)
(a) Perform a diagnostic system check.
Click here .gif)
(b) Visually check for defects with the curtain shield airbag assemblies installed on the vehicle.
(1) The defects are as follows:
- Cuts on each pillar garnish or the roof headlining assembly around the curtain shield airbag assemblies
- Small cracks on each pillar garnish or the roof headlining assembly around the curtain shield airbag assemblies
- Significant discoloration on each pillar garnish or the roof headlining assembly around the curtain shield airbag assemblies
OK:
No defects are found.
HINT:
If any of the defects is found, replace each pillar garnish or the roof headlining assembly with a new one.
2. INSPECT CURTAIN SHIELD AIRBAG ASSEMBLY (for Vehicle Involved in Collision and Airbag not Deployed)
(a) Perform a diagnostic system check.
Click here
(b) Visually check for defects with the curtain shield airbag assemblies installed on the vehicle.
(1) The defects are as follows:
- Cuts on the curtain shield airbag assemblies
- Small cracks on the curtain shield airbag assemblies
- Significant discoloration on the curtain shield airbag assemblies
- Cracks or other damage to the connector
OK:
No defects are found.
HINT:
If any of the defects is found, replace the curtain shield airbag assembly with a new one.
READ NEXT:
Installation
INSTALLATION CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY LH
Components
COMPONENTS ILLUSTRATION *1 DECK FLOOR BOX LH *2 NO. 3 DECK BOARD SUB-ASSEMBLY *3 REAR DECK FLOOR BOX *4 AUXILIARY BATTERY NEGATIVE TERMINAL N*m (kgf*cm, ft.*lbf): Specified
SEE MORE:
Removal
REMOVAL PROCEDURE 1. REMOVE NO. 3 DECK BOARD SUB-ASSEMBLY Click here 2. REMOVE REAR DECK FLOOR BOX Click here 3. REMOVE DECK FLOOR BOX LH Click here 4. PRECAUTION CAUTION: Be sure to read Precaution thoroughly before servicing. Click here NOTICE: After the power switch is turned off, there m
Steering Angle Sensor Communication Error (C1784)
DESCRIPTION Steering sensor signals are sent to the absorber control ECU via CAN communication. When there is a communication malfunction, the malfunction will be detected by the diagnosis function. DTC No. Detection Item DTC Detection Condition Trouble Area Warning Indicate C1784 S
