Lexus NX: Curtain Shield Airbag Assembly
Lexus NX Service Manual / Vehicle Interior / Supplemental Restraint Systems / Curtain Shield Airbag Assembly
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 DECK FLOOR BOX LH *2 NO. 3 DECK BOARD SUB-ASSEMBLY *3 REAR DECK FLOOR BOX *4 AUXILIARY BATTERY NEGATIVE TERMINAL N*m (kgf*cm, ft.*lbf): Specified
On-vehicle Inspection
ON-VEHICLE INSPECTION CAUTION / NOTICE / HINT CAUTION: Be sure to follow the correct removal and installation procedures of the curtain shield airbag assemblies. PROCEDURE 1. INSPECT CURTAIN SHIELD AI
Installation
INSTALLATION CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY LH
SEE MORE:
Fail-safe Chart
FAIL-SAFE CHART LED HEADLIGHT SYSTEM The headlight assembly (light control LED ECU) operates in fail-safe mode if any of the following abnormalities are detected. Item Abnormality Detection Condition Return Condition Multi-information Display Abnormal input voltage (High input voltage)
Removal
REMOVAL PROCEDURE 1. REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY Click here 2. REMOVE FAN AND GENERATOR V BELT Click here 3. REMOVE FRONT SUSPENSION MEMBER REINFORCEMENT RH Click here 4. REMOVE CRANKSHAFT PULLEY ASSEMBLY Click here 5. REMOVE TIMING CHAIN COVER OIL SEAL (a) Using a screwdri
© 2016-2026 Copyright www.lexunx.com
