Lexus NX: Components
COMPONENTS
ILLUSTRATION
.png)
| *1 | DECK FLOOR BOX LH | *2 | NO. 3 DECK BOARD SUB-ASSEMBLY |
| *3 | REAR DECK FLOOR BOX | *4 | AUXILIARY BATTERY NEGATIVE TERMINAL |
.png) | N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
ILLUSTRATION
| *1 | FRONT SEAT CUSHION AIRBAG ASSEMBLY RH | *2 | FRONT SEAT CUSHION SHIELD RH |
| *3 | FRONT SEAT INNER CUSHION SHIELD RH | *4 | FRONT SEAT LOWER CUSHION SHIELD |
| *5 | SEPARATE TYPE SEAT CUSHION COVER WITH PAD | - | - |
| | N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
READ NEXT:
On-vehicle Inspection
ON-VEHICLE INSPECTION CAUTION / NOTICE / HINT CAUTION: Be sure to follow the correct removal and installation procedures of the front seat cushion airbag assembly RH. HINT:
Use the same procedure f
Installation
INSTALLATION CAUTION / NOTICE / HINT CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.
If the front seat cushion airbag assembly RH was deployed, replace the front
Disposal
DISPOSAL CAUTION / NOTICE / HINT CAUTION: Before performing pre-disposal deployment of any SRS part, review and closely follow all applicable environmental and hazardous material regulations. Pre-disp
SEE MORE:
Driving assist systems
To keep driving safety and performance,
the following systems operate
automatically in response to
various driving situations. Be aware,
however, that these systems are
supplementary and should not be
relied upon too heavily when operating
the vehicle.
Summary of the driving assist
systems
Removal
REMOVAL CAUTION / NOTICE / HINT NOTICE:
Do not replace the spiral with sensor cable sub-assembly with the battery connected and the power switch on (IG).
Do not rotate the spiral with sensor cable sub-assembly when the following conditions are met: 1) The steering wheel is removed, 2) the batte
© 2016-2026 Copyright www.lexunx.com
