Lexus NX: On-vehicle Inspection
ON-VEHICLE INSPECTION
CAUTION / NOTICE / HINT
CAUTION:
Be sure to follow the correct removal and installation procedures of the front seat cushion airbag assembly RH.
HINT:
- Use the same procedure for RHD and LHD vehicles.
- The procedure listed below is for LHD vehicles.
PROCEDURE
1. INSPECT FRONT SEAT CUSHION AIRBAG ASSEMBLY RH (for Vehicle not Involved in Collision)
(a) Perform a diagnostic system check.
Click here .gif)
(b) Visually check for defects with the front seat cushion airbag assembly RH installed on the vehicle.
(1) The defects are as follows:
- Cuts on the front seat cushion assembly around the front seat cushion airbag assembly RH
- Small cracks on the front seat cushion assembly around the front seat cushion airbag assembly RH
- Significant discoloration on the front seat cushion assembly around the front seat cushion airbag assembly RH
OK:
No defects are found.
HINT:
If any of the defects is found, replace the separate type front seat cushion cover or separate type front seat cushion pad with a new one.
2. INSPECT FRONT SEAT CUSHION AIRBAG ASSEMBLY RH (for Vehicle Involved in Collision and Airbag not Deployed)
(a) Perform a diagnostic system check.
Click here
(b) Visually check for defects with the front seat cushion airbag assembly RH removed from the vehicle.
(1) The defects are as follows:
- Make sure that there are no broken or frayed threads, or scratches on the surface of the base fabric of the front seat cushion airbag assembly RH
- Marks from being dropped
- Deformation on the installation part of the front seat cushion airbag assembly RH
- Cracks or other damage to the wire harness or connector
OK:
No defects are found.
HINT:
If any of the defects is found, replace the front seat cushion airbag assembly RH with a new one.
READ NEXT:
Installation
INSTALLATION CAUTION / NOTICE / HINT CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.
If the front seat cushion airbag assembly RH was deployed, replace the front
Disposal
DISPOSAL CAUTION / NOTICE / HINT CAUTION: Before performing pre-disposal deployment of any SRS part, review and closely follow all applicable environmental and hazardous material regulations. Pre-disp
SEE MORE:
Check Mode Procedure
CHECK MODE PROCEDURE HINT: Compared to normal mode, check mode is more sensitive to malfunctions. Therefore, check mode can detect malfunctions that cannot be detected in normal mode. NOTICE: All the stored DTCs and freeze frame data are cleared if: 1) the ECM is changed from normal mode to check mo
Installation
INSTALLATION PROCEDURE 1. INSTALL PARKING ASSIST ECU (a) Temporarily install a new nut (A) so that the nut cannot fall, but do not tighten it. *a Nut A *b Nut B Connector (b) Connect the 3 connectors. (c) Insert nut (A) into the hole in the body and slide downward to temporaril
