Lexus NX: Installation
INSTALLATION
CAUTION / NOTICE / HINT
CAUTION:
- Wear protective gloves. Sharp areas on the parts may injure your hands.
- If the front seat cushion airbag assembly RH was deployed, replace the front seat cushion airbag assembly RH, separate type front seat cushion spring assembly, separate type front seat cushion cover and separate type front seat cushion pad with the necessary parts in accordance with the extent of the collision damage.
PROCEDURE
1. INSTALL FRONT SEAT CUSHION AIRBAG ASSEMBLY RH
(a) Attach the 3 wire harness clamps to set the front seat cushion airbag assembly RH.
(b) Install the front seat cushion airbag assembly RH with 3 new nuts.
Torque:
5.5 N·m {56 kgf·cm, 49 in·lbf}
CAUTION:
- The nuts must not be reused.
- Make sure that the separate type front seat cushion spring assembly is not deformed. If it is, replace it with a new one.
(c) Attach the claw to connect the airbag connector.
(d) Attach the 3 wire harness clamps.
2. INSTALL SEPARATE TYPE SEAT CUSHION COVER WITH PAD
Click here .gif)
3. INSTALL FRONT SEAT INNER CUSHION SHIELD RH
Click here
4. INSTALL FRONT SEAT CUSHION SHIELD RH
Click here
5. INSTALL FRONT SEAT LOWER CUSHION SHIELD
Click here
6. INSTALL FRONT SEAT ASSEMBLY RH
Click here
7. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
(a) Connect the cable to the negative (-) auxiliary battery terminal and tighten the nut.
Torque:
5.4 N·m {55 kgf·cm, 48 in·lbf}
8. INITIALIZATION AFTER RECONNECTING AUXILIARY BATTERY TERMINAL
Click here
HINT:
When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.
Click here
9. INSTALL DECK FLOOR BOX LH
Click here
10. INSTALL REAR DECK FLOOR BOX
Click here
11. INSTALL NO. 3 DECK BOARD SUB-ASSEMBLY
Click here
12. PERFORM DIAGNOSTIC SYSTEM CHECK
Click here
13. CHECK SRS WARNING LIGHT
Click here
READ NEXT:
Disposal
DISPOSAL CAUTION / NOTICE / HINT CAUTION: Before performing pre-disposal deployment of any SRS part, review and closely follow all applicable environmental and hazardous material regulations. Pre-disp
Components
COMPONENTS ILLUSTRATION *1 DECK FLOOR BOX LH *2 NO. 3 DECK BOARD SUB-ASSEMBLY *3 REAR DECK FLOOR BOX *4 AUXILIARY BATTERY NEGATIVE TERMINAL N*m (kgf*cm, ft.*lbf): Specified
SEE MORE:
Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART Power Steering System DTC No. Detection Item Warning Indicate Return-to-normal Condition Note Link C1511 Torque Sensor1 On Power switch on (IG) again - C1512 Torque Sensor2 On Power switch on (IG) again - C1513 Torque
Portable Player cannot be Operated Using In-vehicle Device or Track Information is not Displayed on In-vehicle Device
PROCEDURE 1. CHECK USING ANOTHER "Bluetooth" AUDIO COMPATIBLE VEHICLE OF SAME MODEL (a) Check if track information is displayed normally on another "Bluetooth" audio compatible vehicle of the same model. OK: Track information is displayed normally. OK PROCEED TO NEXT SUSPECTED AREA
