Lexus NX: Customize Parameters
Lexus NX Service Manual / Vehicle Exterior / Lighting (ext) / Afs (adaptive Front-lighting System) / Customize Parameters
CUSTOMIZE PARAMETERS
CUSTOMIZE AFS (ADAPTIVE FRONT-LIGHTING SYSTEM)
NOTICE:
- When the customer requests a change in a function, first make sure that the function can be customized.
- Be sure to make a note of the current settings before customizing.
- When troubleshooting a function, first make sure that the function is set to the default setting.
HINT:
The following items can be customized.
(a) Customizing with the Techstream
(1) Connect the Techstream to the DLC3.
(2) Turn the power switch on (IG).
(3) Turn the Techstream on.
(4) Enter the following menus: Customize Setting / Light Control.
(5) Select the setting by referring to the table below.
Light Control| Tester Display | Description | Default | Setting | ECU |
|---|---|---|---|---|
| AFS Function | Turns the AFS (front-lighting adaptive system) function on/off. | ON | 0:ON,1:OFF | Headlight ECU sub-assembly LH |
READ NEXT:
Initialization
INITIALIZATION NOTICE:
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during headlight
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE NOTICE: If the headlight ECU sub-assembly LH has been replaced, it is necessary to synchronize the vehicle information and initialize the headlight ECU sub-assembly LH. Click he
Terminals Of Ecu
TERMINALS OF ECU CHECK MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) AND INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY Click here CHECK HEADLIGHT ECU SUB-ASSEMBLY LH Click here CHECK HEADLIGHT ECU SUB-ASS
SEE MORE:
Washer Nozzle
ComponentsCOMPONENTS ILLUSTRATION *1 HOOD INSULATOR *2 WASHER NOZZLE SUB-ASSEMBLY *3 WASHER HOSE - - ● Non-reusable part - - On-vehicle InspectionON-VEHICLE INSPECTION PROCEDURE 1. INSPECT WASHER NOZZLE SUB-ASSEMBLY (a) With the power switch turned on (IG), check
Disassembly
DISASSEMBLY CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. REMOVE NO. 3 MOULDING TAPE (a) Remove the No. 3 moulding tape. HINT: Do not pull on the No. 3 moulding tape. Instead, roll the tape up with y
© 2016-2026 Copyright www.lexunx.com
