Lexus NX: Afs (adaptive Front-lighting System)
- Precaution
- Parts Location
- System Diagram
- How To Proceed With Troubleshooting
- Operation Check
- Customize Parameters
- Initialization
- Problem Symptoms Table
- Terminals Of Ecu
- Dtc Check / Clear
- Freeze Frame Data
- Data List / Active Test
- Diagnostic Trouble Code Chart
- Headlight Swivel ECU LH Communication (B2410,B2411,B2424,B2425)
- Headlight Swivel Motor LH (B2412,B2413)
READ NEXT:
Precaution
PRECAUTION PRECAUTION WHEN REPLACING HEADLIGHT ECU SUB-ASSEMBLY LH (a) If the headlight ECU sub-assembly LH has been replaced, it is necessary to synchronize the vehicle information and initialize the
Parts Location
PARTS LOCATION ILLUSTRATION *1 HEADLIGHT ECU SUB-ASSEMBLY LH *2 HEADLIGHT ECU SUB-ASSEMBLY RH *3 HEADLIGHT ASSEMBLY LH - HEADLIGHT UNIT ASSEMBLY LH *4 HEADLIGHT ASSEMBLY RH - HEADL
System Diagram
SYSTEM DIAGRAM
SEE MORE:
Check Mode Procedure
CHECK MODE PROCEDURE NOTICE: Enter "Signal Check" from the "DTC Check" screen displayed on the Techstream to clear the output DTCs (both present and past). HINT:
DTCs can be stored more sensitively in check mode than in normal diagnosis mode.
Perform the check mode inspection when a malfunction
Brake Hold Standby Indicator Light Circuit
DESCRIPTION The brake hold standby indicator light turns on if brake hold control is possible when the following conditions required for operation standby are met and the brake hold switch (integration control and panel assembly) is turned on while the power switch is on (IG).
Conditions required
© 2016-2026 Copyright www.lexunx.com
