Lexus NX manuals

Lexus NX: Dcm Activation

Lexus NX Service Manual / Audio & Visual & Telematics / Cellular Communication / Safety Connect System / Dcm Activation

DCM ACTIVATION

DCM ACTIVATION

(a) Connect the Techstream to the DLC3.

(b) Turn the power switch on (IG).

(c) Turn the Techstream on.

(d) Choose "Telematics" from the System Selection Menu, and then click "Utility".

(e) Click "VIN Synchronization" on the Utility Selection Menu.

Body Electrical > Telematics > Utility

Tester Display

VIN Synchronization

(f) According to the display on the Techstream, read the IMEI, ICCID, software version and VIN.

(g) Turn the power switch off.

(h) Turn the power switch on (IG) and wait until only the manual (SOS) green indicator turns on.

HINT:

If only the manual (SOS) switch green indicator does not turn on even after 20 minutes elapse with the power switch on (IG), refer to "GREEN INDICATOR REMAINS OFF".

Click here

READ NEXT:

 Acn Call End

ACN CALL END ACN CALL END This function terminates the ACN (Automatic Collision Notification) to the telematics provider. After a collision in which the DCM receives "Collision Detection Signal", the

 Customize Parameters

CUSTOMIZE PARAMETERS CUSTOMIZE TELEMATICS SYSTEM (a) Customizing with the Techstream. NOTICE: When the customer requests a change in a function, first make sure that the function can be customized.

 Initialization

INITIALIZATION RESET BACK-UP BATTERY CONDITION HINT: If the back-up battery (mobilephone battery) has been replaced, it is necessary to perform the Reset Backup Battery Condition procedure. (a) Connec

SEE MORE:

 Removal

REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. PROCEDURE 1. PRECAUTION NOTICE: After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary

 Drive Motor "A" Position Sensor Circuit (P0A3F-243,P0A40-500,P0A41-245)

DTC SUMMARY MALFUNCTION DESCRIPTION These DTCs indicate the resolver output signal is abnormal. The cause of this malfunction may be one of the following: Area Main Malfunction Description Step Inverter low-voltage circuit The connectors are not connected properly 2 Resolver

© 2016-2026 Copyright www.lexunx.com