Lexus NX: Components
COMPONENTS
ILLUSTRATION
| *A | for Driver Side | *B | for Front Passenger Side |
| *1 | FRONT INNER SEAT CUSHION SHIELD LH | *2 | FRONT LOWER SEAT CUSHION SHIELD |
| *3 | FRONT SEAT CUSHION SHIELD LH | *4 | FRONT SEAT INNER BELT ASSEMBLY LH |
| *5 | FRONT SEAT INNER BELT ASSEMBLY RH | *6 | SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD LH |
| *7 | FRONT SEAT BELT ANCHOR PLATE | - | - |
.png) | N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
ILLUSTRATION
| *1 | SEPARATE TYPE FRONT SEAT CUSHION COVER LH | *2 | SEPARATE TYPE FRONT SEAT CUSHION PAD LH |
| *3 | HOG RING | - | - |
| ● | Non-reusable part | - | - |
READ NEXT:
Removal
REMOVAL CAUTION / NOTICE / HINT CAUTION: Wear protective gloves. Sharp areas on the parts may injure your hands. HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below i
Inspection
INSPECTION PROCEDURE 1. INSPECT SEPARATE TYPE FRONT SEAT CUSHION COVER LH *1 Connector A *2 Connector B *a Component without harness connected (Separate Type Front Seat Cushion Cover
Installation
INSTALLATION CAUTION / NOTICE / HINT CAUTION: Wear protective gloves. Sharp areas on the parts may injure your hands. HINT:
Use the same procedure for the RH and LH sides.
The procedure listed be
SEE MORE:
Dtc Check / Clear
DTC CHECK / CLEAR DTC CHECK USING TECHSTREAM (a) Connect the Techstream to the DLC3. (b) Turn the power switch on (IG). (c) Turn the Techstream on. (d) Enter the following menus: Body Electrical / Air Conditioner / Trouble Codes. (e) Check for DTCs. Click here Body Electrical > Air Conditioner &
Master Module Horizontal Axis Misalignment (C1AC1)
DESCRIPTION This DTC is stored when the angle of the blind spot monitor sensor LH deviates more than the allowable range from the horizontal axis. HINT: If a drum tester such as a speedometer tester, brake/speedometer combination tester or chassis dynamometer is used with the blind spot monitor main
© 2016-2026 Copyright www.lexunx.com
