Lexus NX: Diagnosis System
Lexus NX Service Manual / Engine & Hybrid System / Cruise Control / Front Radar Sensor System / Diagnosis System
DIAGNOSIS SYSTEM
DIAGNOSIS FUNCTION
(a) If a malfunction is detected in the millimeter wave radar sensor assembly, the millimeter wave radar sensor assembly stores DTCs without directly informing the driver, and sends malfunction signals to the systems that use the millimeter wave radar sensor assembly.
Those systems then notify the driver.
HINT:
Refer to "HOW TO PROCEED WITH TROUBLESHOOTING" when troubleshooting for the Pre-collision System.
Click here .gif)
READ NEXT:
Dtc Check / Clear
DTC CHECK / CLEAR CHECK DTC (a) Connect the Techstream to the DLC3. (b) Turn the power switch on (IG). (c) Turn the Techstream on. (d) Enter the following menus: Body Electrical / Front Radar Sensor /
Freeze Frame Data
FREEZE FRAME DATA DESCRIPTION (a) Whenever a front radar sensor system DTC is stored, the millimeter wave radar sensor assembly stores the current vehicle state as Freeze Frame Data. CHECK FREEZE FRAM
Fail-safe Chart
FAIL-SAFE CHART FAIL-SAFE FUNCTION (a) If a malfunction is detected in the front radar sensor system, a message is displayed on the multi-information display and systems related to the malfunction are
SEE MORE:
Illumination for Panel Switch does not Come on with Tail Switch ON
CAUTION / NOTICE / HINT NOTICE: When replacing the radio receiver assembly, always replace it with a new one. If a radio receiver assembly which was installed to another vehicle is used, the following may occur:
A communication malfunction DTC may be stored.
The radio receiver assembly may not
Internal Control Module Monitoring Processor Performance (P060A)
MONITOR DESCRIPTION The main CPU and sub CPU of the ECM perform data communication between each other. The main CPU monitors the communication and WDC pulses from the sub CPU. When the signal malfunctions below are detected, this DTC is stored. DTC No. Detection Item DTC Detection Condition
© 2016-2026 Copyright www.lexunx.com
