Lexus NX: Dtc Check / Clear
DTC CHECK / CLEAR
CHECK DTC
(a) Connect the Techstream to the DLC3.
(b) Turn the power switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Front Radar Sensor / Trouble Codes.
Body Electrical > Front Radar Sensor > Trouble Codes(e) Check for DTCs (Test Failed / Pending / Confirmed).
| Techstream Display | Description |
|---|---|
| Test Failed | Shows the malfunction judgment results during the current trip. |
| Pending | Shows the malfunction judgment results up to now. (Indicates the possibility of a malfunction when no DTC is confirmed.) |
| Confirmed | Shows the DTCs confirmed up to now. (The number of current trips differs for each DTC.) |
HINT:
Freeze frame data is stored respectively for pending DTCs, confirmed DTCs and the latest DTCs.
CLEAR DTC
(a) Connect the Techstream to the DLC3.
(b) Turn the power switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Front Radar Sensor / Clear DTCs.
Body Electrical > Front Radar Sensor > Clear DTCs(e) Clear the DTCs.
HINT:
Clearing the DTCs will also clear the freeze frame data.
READ NEXT:
Freeze Frame Data
FREEZE FRAME DATA DESCRIPTION (a) Whenever a front radar sensor system DTC is stored, the millimeter wave radar sensor assembly stores the current vehicle state as Freeze Frame Data. CHECK FREEZE FRAM
Fail-safe Chart
FAIL-SAFE CHART FAIL-SAFE FUNCTION (a) If a malfunction is detected in the front radar sensor system, a message is displayed on the multi-information display and systems related to the malfunction are
Data List / Active Test
DATA LIST / ACTIVE TEST DATA LIST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a pa
SEE MORE:
Inspection
INSPECTION PROCEDURE 1. INSPECT BENCH TYPE REAR SEAT CUSHION COVER (REAR SEAT CUSHION HEATER ASSEMBLY RH) (a) Check the bench type rear seat cushion cover (rear seat cushion heater assembly RH). NOTICE: Disconnect the connector B from the rear seat cushion heater assembly LH before checking it. (
Components
COMPONENTS ILLUSTRATION *1 DECK TRIM SIDE PANEL ASSEMBLY RH *2 LUGGAGE HOLD BELT STRIKER ASSEMBLY *3 NO. 1 LUGGAGE COMPARTMENT TRIM HOOK *4 PARKING ASSIST ECU *5 REAR DOOR OPENING TRIM WEATHERSTRIP RH *6 REAR FLOOR FINISH PLATE *7 ROPE HOOK ASSEMBLY *8 UPPER D
