Lexus NX: Diagnosis System
Lexus NX Service Manual / Audio & Visual & Telematics / Park Assist / Monitoring / Intelligent Clearance Sonar System / Diagnosis System
DIAGNOSIS SYSTEM
DESCRIPTION
(a) Intelligent clearance sonar system data and Diagnostic Trouble Codes (DTCs) can be read from the Data Link Connector 3 (DLC3) of the vehicle. When the system seems to be malfunctioning, use the Techstream to check for malfunctions and to repair them.
CHECK DLC3
(a) Check the DLC3.
Click here .gif)
DESCRIPTION
(a) When the intelligent clearance sonar system is unavailable either temporarily or due to a malfunction, a warning message is displayed on the multi-information display.
Multi-information Display Warning Message| Warning Message | Proceed to |
|---|---|
| "Parking Support Brake Malfunction Visit Your Dealer" | |
| "Parking Support Brake Unavailable" |
READ NEXT:
Dtc Check / Clear
DTC CHECK / CLEAR CHECK DTC (a) Connect the Techstream to the DLC3. (b) Turn the power switch on (IG). (c) Turn the intelligent clearance sonar system on. (d) Turn the Techstream on. (e) Enter the fol
Fail-safe Chart
FAIL-SAFE CHART FAIL-SAFE FUNCTION (a) If a malfunction is detected in the intelligent clearance sonar system, the warning message "Parking Support Brake System Malfunction Visit Your Dealer" or "Park
Data List / Active Test
DATA LIST / ACTIVE TEST DATA LIST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a pa
SEE MORE:
Check Mode Procedure
CHECK MODE PROCEDURE HINT: Compared to normal mode, check mode is more sensitive to malfunctions. Therefore, check mode can detect malfunctions that cannot be detected in normal mode. NOTICE: All the stored DTCs and freeze frame data are cleared if: 1) the ECM is changed from normal mode to check mo
Installation
INSTALLATION CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure described below is for the LH side.
PROCEDURE 1. INSTALL FOG LIGHT ASSEMBLY LH (a) Install the fog light assembly LH with the 3 screws. (b) Attach each hose clamp. *A LH Side *B
© 2016-2026 Copyright www.lexunx.com
