Lexus NX: Driving procedures
Lexus NX Owners Manual / Driving / Driving procedures
READ NEXT:
Power (ignition) switch
Performing the following operations
when carrying the electronic
key on your person starts the hybrid
system or changes power switch
modes.
Starting the hybrid system
1. Check that the parking b
EV drive mode
In EV drive mode, electric power is
supplied by the hybrid battery
(traction battery), and only the
electric motor (traction motor) is
used to drive the vehicle.
This mode allows you to drive i
Hybrid transmission
Select the shift position depending
on your purpose and situation.
Shift position purpose and functions
*1: To improve fuel efficiency and reduce
noise, shift the shift lever to D for normal
dr
SEE MORE:
On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT STOP LIGHT SWITCH ASSEMBLY (a) Disconnect the stop light switch assembly connector. *a Front view of wire harness connector (to Stop Light Switch Assembly) (b) Measure the voltage and resistance on the wire harness side connector
Installation
INSTALLATION PROCEDURE 1. INSTALL TIMING CHAIN COVER ASSEMBLY (a) Apply a light coat of engine oil to the 3 new gaskets. (b) Install the 3 gaskets to the stiffening crankcase assembly. (c) Align the positions of the drive rotor spline and crankshaft timing sprocket as shown in the illustration.
© 2016-2026 Copyright www.lexunx.com
