Lexus NX: Dtc Check / Clear
DTC CHECK / CLEAR
CHECK DTC
(a) Connect the Techstream to the DLC3.
(b) Turn the power switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Chassis / Front Recognition Camera / Trouble Codes.
Chassis > Front Recognition Camera > Trouble Codes(e) Check for DTCs.
| Techstream Display | Description |
|---|---|
| Test Failed | Shows the malfunction judgment results during the current trip. |
| Pending | Shows the malfunction judgment results up to now. (Indicates the possibility of a malfunction when no DTC is confirmed.) |
| Confirmed | Shows the DTCs confirmed up to now. (The number of current trips differs for each DTC.) |
CLEAR DTC
(a) Connect the Techstream to the DLC3.
(b) Turn the power switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Chassis / Front Recognition Camera / Clear DTCs.
Chassis > Front Recognition Camera > Clear DTCs(e) Clear the DTCs.
READ NEXT:
Freeze Frame Data
FREEZE FRAME DATA DESCRIPTION (a) When a front camera system DTC is stored, the forward recognition camera stores the current vehicle (ECU or sensor) state as Freeze Frame Data. CHECK FREEZE FRAME DAT
Fail-safe Chart
FAIL-SAFE CHART FRONT CAMERA SYSTEM FAIL-SAFE CHART (a) When a malfunction occurs in the front camera system, a message is displayed on the multi-information display and control is canceled in accorda
Data List / Active Test
DATA LIST / ACTIVE TEST DATA LIST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. Th
SEE MORE:
Rear Center Seat Outer Belt Assembly
ComponentsCOMPONENTS ILLUSTRATION *1 REAR CENTER SEAT OUTER BELT ASSEMBLY *2 SEAT BELT ANCHOR COVER N*m (kgf*cm, ft.*lbf): Specified torque - - RemovalREMOVAL PROCEDURE 1. REMOVE SEAT BELT ANCHOR COVER (a) Using moulding remover D, detach the 2 claws. (b) Det
Operation Check
OPERATION CHECK CHECK SLIDING ROOF NOTICE:
If the negative battery terminal is disconnected under the following conditions, initialization of the sliding roof drive gear sub-assembly may not be completed. In this case, perform initialization.
Within 2 seconds after roof glass operation stops.
