Lexus NX: Dtc Check / Clear

DTC CHECK / CLEAR

CHECK FOR DTC

(a) Turn the power switch off.

(b) Connect the Techstream to the DLC3.

(c) Turn the power switch on (IG).

(d) Turn the Techstream on.

(e) Enter the following menus: Body Electrical / Back Door / Trouble Codes.

(f) Check for DTCs.

Click here

Body Electrical > Back Door > Trouble Codes

CLEAR DTC

(a) Turn the power switch off.

(b) Connect the Techstream to the DLC3.

(c) Turn the power switch on (IG).

(d) Turn the Techstream on.

(e) Enter the following menus: Body Electrical / Back Door / Trouble Codes.

(f) Clear the DTCs.

Click here

Body Electrical > Back Door > Clear DTCs

READ NEXT:

 Data List / Active Test

DATA LIST / ACTIVE TEST DATA LIST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. Th

 Diagnostic Trouble Code Chart

DIAGNOSTIC TROUBLE CODE CHART Back Door Closer System DTC No. Detection Item Link B2250 Back Door Closer Operation Malfunction B2251 Back Door Closer Switch Malfunction

 Back Door Closer Operation Malfunction (B2250)

DESCRIPTION The multiplex network door ECU receives signals from the latch switch, initial switch, pawl switch and back door courtesy switch, which are built into the back door lock assembly. Based on

SEE MORE:

 Reassembly

REASSEMBLY CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. PROCEDURE 1. INSTALL REAR COMBINATION LIGHT SOCKET AND WIRE SUB-ASSEMBLY LH NOTICE: Prevention of static electricity is required during this procedure.

 Software Incompatibility with Body Control Module "B" (U1331)

DESCRIPTION This DTC is stored when the destination information of the main body ECU (multiplex network body ECU) does not match that of the blind spot monitor sensors. DTC No. Detection Item DTC Detection Condition Trouble Area Note U1331 Software Incompatibility with Body Control

© 2016-2026 Copyright www.lexunx.com