Lexus NX: Dtc Check / Clear
Lexus NX Service Manual / Vehicle Exterior / Door / Hatch / Power Back Door System / Dtc Check / Clear
DTC CHECK / CLEAR
CHECK FOR DTC
(a) Turn the power switch off.
(b) Connect the Techstream to the DLC3.
(c) Turn the power switch on (IG).
(d) Turn the Techstream on.
(e) Enter the following menus: Body Electrical / Back Door / Trouble Codes.
(f) Check for DTCs.
Body Electrical > Back Door > Trouble CodesCLEAR DTC
(a) Turn the power switch off.
(b) Connect the Techstream to the DLC3.
(c) Turn the power switch on (IG).
(d) Turn the Techstream on.
(e) Enter the following menus: Body Electrical / Back Door / Trouble Codes.
(f) Clear the DTCs.
Body Electrical > Back Door > Clear DTCsREAD NEXT:
Terminals Of Ecu
TERMINALS OF ECU CHECK MULTIPLEX NETWORK DOOR ECU (a) Disconnect the Y26 and Y27 multiplex network door ECU connectors. (b) Measure the voltage and resistance according to the value(s) in the table b
Freeze Frame Data
FREEZE FRAME DATA FREEZE FRAME DATA (a) Whenever a DTC is detected, the multiplex network door ECU stores the current vehicle state as Freeze Frame Data. CHECK FREEZE FRAME DATA (a) Turn the power swi
Data List / Active Test
DATA LIST / ACTIVE TEST DATA LIST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. Th
SEE MORE:
Removal
REMOVAL CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. REMOVE NO. 3 DECK BOARD SUB-ASSEMBLY Click here 2. REMOVE REAR DECK FLOOR BOX Click here 3. REMOVE DECK FLOOR BOX LH Click here 4. PRECAUTIO
On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT THROTTLE WITH MOTOR BODY ASSEMBLY (a) Put the engine in inspection mode (maintenance mode). Click here (b) Start the engine and check that the MIL is not illuminated. After the engine is warmed up, check that the idle speed is within the specified range w
© 2016-2026 Copyright www.lexunx.com
